14 October 2023 in Construction and Building Materials
1 March 2023 in Proceedings of the Institution of Civil Engineers - Construction Materials
In this paper, ultra-high-performance concrete (UHPC) and its constituents were evaluated by way of instrumented and non-instrumented mechanical-property tests and imaging techniques. Through image analysis, the average size, per cent area, nearest-neighbour distance and relative number density of each inclusion type were determined. Instrumented mechanical-property testing was conducted to obtain estimates for the relative behaviour of UHPC's various constituents. Different combinations of constituents were produced to measure indirect tensile strength, compressive strength, elastic modulus, Poisson's ratio and overall stress–strain behaviour to failure at early and later ages. Stress–strain behaviour and Poisson's ratio of UHPC aligned well with the literature, while constituents of UHPC also showed linear stress–strain relationships and comparable Poisson's ratios. Tensile behaviour at early and late ages was characterised and was found to be driven by inclusion of fibres. Characterisation of UHPC and its constituents is envisioned to be used to further modelling efforts by basing mathematical relationships on physical measurements.
1 March 2019 in Advances in Civil Engineering Materials
This research focused on improving ultra high-performance concrete (UHPC) toughness through the addition of annealed plain carbon steel fibers and stainless steel fibers that both exhibit increased ductility and strain hardening compared with conventional steel fibers used for concrete reinforcement. Implementing optimized heat treatments and selecting proper alternative alloys can improve the postyield carrying capacity of UHPCs through plastic deformations, phase transformations, and fiber pullout. This research focused on the flexural response and dynamic penetration resistance of a UHPC known as Cor-Tuf with three different steel fiber types: plain carbon steel, stainless steel that can exhibit phase transformation-induced plasticity, and annealed carbon steel with reduced tensile strength but increased ductility and strain hardening. Annealed carbon steel fibers were able to reduce mass loss by 0.8 % for 5-cm-thick dynamic impact panels. By using a phase-transformable stainless steel, the ultimate flexural strength increased from 32.0 to 42.5 MPa (33 % increase) and the postimpact velocity decreased an average of 31.5 m/s for 2.5 and 5-cm-thick dynamic impact panels. Phase transformations (austenitic to martensitic) were quantified in the stainless steel fibers of postyielded UHPC specimens using a vibrating sample magnetometer. Stainless steel fibers sampled from the postyielded tensile face of a flexural beam increased from 75 to 107 emu/g. The results of the study evidence improvements in tensile properties and toughness that can be accomplished by modifying the stress versus strain response of steel fiber reinforcement and including new energy dissipation mechanisms such as phase transformation.
1 January 2006 in Yearbook of Dentistry