Danielle Griffith

Danielle Griffith

Auto-generated profile, based on publicly available information

Danielle Griffith

Texas Instruments,Dallas,TX,USA

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 September 2019 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
KMKarim M. Megawer
Karim M. Megawer
NPNilanjan Pal
Nilanjan Pal
AEAhmed Elkholy
Ahmed Elkholy
MAMostafa Gamal Ahmed
Mostafa Gamal Ahmed
AKAmr Khashaba
Amr Khashaba
PHPavan Kumar Hanumolu
Pavan Kumar Hanumolu
Fast startup crystal oscillators (XOs) are needed in heavily duty-cycled communication systems for implementing aggressive dynamic power management schemes. This article presents the ways to improve startup time of XOs. Using a two-step injection technique in a three-step process, the proposed technique reduces the XO startup time to within 1.5x the theoretical minimum. By solving the differential equation governing crystal resonator under injection for arbitrary injection frequency, the behavior of energy build-up inside a crystal resonator is analyzed and used to determine optimum injection time as a function of the desired XO steady-state amplitude and injection frequency error. Bounds on tolerable injection frequency error to guarantee the existence of optimal timing are provided. Fabricated in a 65-nm CMOS process, the proposed 54-MHz fast startup XO occupies an active area of 0.075 mm² and achieves a startup time of less than 20 μs across a temperature range of -40 °C to 85 °C while consuming a startup energy of 34.9 nJ and operating from a 1.0-V supply.

15 November 2022 in IEEE Solid-State Circuits Magazine
Verified
Journal Article
Closed access
DGDanielle Griffith
Danielle Griffith
The low power IoT market began in earnest in 1999 with the launch of the first commercial Bluetooth device. In 2021, IoT Analytics Research, a market research firm, predicted [1] a yearly 22% growth rate in the global IoT market over the next three years. By 2025, the installed base of active IoT gateways is expected to be 27 billion, not including laptops, tablets, and cellphones. In this projection, gateways are counted, not every sensor. Therefore, the number of connected radios in 2025 is going to be higher than the forecast of 27 billion, perhaps much higher. The IoT market is likely to continue growing past 2025, but this growth rate is unsustainable with today’s technology. This article discusses three limitations to IoT market growth: power, cost, and performance. Examples of innovations needed to enable the predicted market growth will be presented in each area. At the end, a prediction for IoT wireless nodes in the coming decade is presented.

3 December 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
TWTianyu Wang
Tianyu Wang
DGDanielle Griffith
Danielle Griffith
MAMostafa G. Ahmed
Mostafa G. Ahmed
JZJunheng Zhu
Junheng Zhu
DWDa Wei
Da Wei
PHPavan Kumar Hanumolu
Pavan Kumar Hanumolu
A low power RC relaxation oscillator with very low voltage and temperature sensitivities is presented. Supply sensitivity is reduced by using a self-regulation loop that biases the oscillator near its zero-voltage coefficient point. Fabricated in a 65-nm CMOS process, the prototype 1.5-MHz oscillator consumes 6 μW from 1-V supply and achieves better than ±50 ppm〉°C and ±1500 ppm/V temperature and voltage sensitivities, respectively.

21 July 2006
Verified
Conference Paper
Closed access
NYN.K. Yanduru
N.K. Yanduru
DGD. Griffith
D. Griffith
SBS. Bhagavatheeswaran
S. Bhagavatheeswaran
CCChien-Chung Chen
Chien-Chung Chen
FDF. Dulger
F. Dulger
KLKah Mun Low
Kah Mun Low

1 June 2013
Verified
Conference Paper
Closed access
SCSudipto Chakraborty
Sudipto Chakraborty
VPViral Parikh
Viral Parikh
SSSwaminathan Sankaran
Swaminathan Sankaran
TMTomas Motos
Tomas Motos
IPIndu Prathapan
Indu Prathapan
PCPatrick Cruise
Patrick Cruise
This paper presents an energy efficient transmitter for multi-standard applications (IEEE802.15.4, BLE, 5Mbps) in ISM2.4GHz band. It incorporates a fully digital PLL with two point modulation to achieve upto 5Mbps data rate at 9.5mW power consumption (including all power management blocks) at 0dBm output power, leading to 1.9nJ/b efficiency. The proposed digital PLL uses a counter based area and power efficient re-circulating TDC, current reuse low area DCO using resistive tail, process compensated high speed divider, class-AB PA stages, and fully integrated on-chip LDOs. The entire transmitter occupies 0.35mm2 Silicon area in a 65nm digital CMOS process.

15 May 2023
Verified
Conference Paper
Closed access
DGDanielle Griffith
Danielle Griffith
SummaryAll IoT devices require a clock source for computation and communication. Crystal oscillators have been the standard clock source when an accurate, low power reference frequency is needed, but the growing IoT market demands improvements in five areas. These are reduced phase noise for higher data rate communication, faster startup time for duty-cycled systems, smaller physical size for further integration, improved environmental robustness, and resistance to tampering. Reference clocks built from MEMS resonators, including bulk acoustic wave (BAW) resonators, are uniquely suited to meet these requirements.