30 January 2025 in Journal of Materials Research and Technology
3 December 2018 in IEEE Transactions on Circuits and Systems II: Express Briefs
A low power RC relaxation oscillator with very low voltage and temperature sensitivities is presented. Supply sensitivity is reduced by using a self-regulation loop that biases the oscillator near its zero-voltage coefficient point. Fabricated in a 65-nm CMOS process, the prototype 1.5-MHz oscillator consumes 6 μW from 1-V supply and achieves better than ±50 ppm〉°C and ±1500 ppm/V temperature and voltage sensitivities, respectively.
17 January 2018 in IEEE Journal of Solid-State Circuits
A low-power source-synchronous multi-Gb/s transceiver is presented. Supply voltage is aggressively scaled to reduce power, and the speed penalty resulting from low-voltage operation is overcome by multiplexing transmitter/receiver synchronized by low-rate multi-phase clocks. Phase spacing errors incurred by device mismatches are corrected using a self-calibration scheme. The proposed phase calibration method uses a single digital DLL to calibrate all the phases, which makes it insensitive to offsets in the calibrating DLL. Fabricated in a 65-nm CMOS process, energy efficiency and data rate of the prototype transceiver vary from 0.29 to 0.58 pJ/bit and 1 to 6 Gb/s, respectively, as the supply voltage changes from 0.45 to 0.7 V.
28 December 2017 in IEEE Journal of Solid-State Circuits
Modern multiprocessor system-on-chips employ network-on-chip (NoC) to efficiently connect different components together. NoCs need global and local interconnects to deliver high on-chip bandwidth and low communication latency to avoid being a performance bottleneck. They must also have high throughput density to reduce area occupied by wires. This paper presents techniques to implement power efficient transceivers for on-chip links that can achieve energy proportional operation. Conventional on-chip links optimized for best energy efficiency at peak data rate suffer from degraded energy efficiency under low utilization conditions. Dynamic voltage and frequency scaling and clock gating can partially alleviate this problem, but become ineffective in applications like mobile devices, where the data traffic can be very sporadic. In this paper, architecture and circuit techniques to improve energy efficiency under all utilization levels are presented. The proposed transceiver uses single-ended signaling with only 0.5 μm width and spacing and achieves 5-Gb/μm throughput density. Fast locking signaling and clocking circuits greatly reduce the power-ON time. Fabricated in 65-nm CMOS technology, the proposed 10-Gb/s transceiver achieves wake-up time in less than 17 ns. More than 125× effective data rate scaling (10 Gb/s to 80 Mb/s) is obtained with an energy efficiency degradation of only 1.6× (627 to 997 fJ/b/mm). When the supply voltage is scaled from 1 to 0.7 V, the peak data rate scales from 10 to 6 Gb/s and the power scalable range increases to 208× (10 Gb/s to 48 Mb/s) with the energy efficiency degradation of only 1.2× (627 to 753 fJ/b/mm).