Roland May

Roland May

Auto-generated profile, based on publicly available information

Roland May

Baker Hughes, a GE Company, Celle, Germany

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2018 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
SBSilvio Baldino
Silvio Baldino
ROReza E. Osgouei
Reza E. Osgouei
EOEvren Ozbayoglu
Evren Ozbayoglu
SMStefan Z. Miska
Stefan Z. Miska
RMRoland May
Roland May

1 April 2015 in Journal of Petroleum Science and Engineering
Verified
Journal Article
Closed access
OEOney Erge
Oney Erge
EOEvren M. Ozbayoglu
Evren M. Ozbayoglu
SMStefan Z. Miska
Stefan Z. Miska
MYMengjiao Yu
Mengjiao Yu
NTNicholas Takach
Nicholas Takach
RMRoland May
Roland May

14 January 2019 in EPJ Web of Conferences
Verified
Journal Article
Open access
YIYaroslav Ignatenko
Yaroslav Ignatenko
AGAndrey Gavrilov
Andrey Gavrilov
OBOleg Bocharov
Oleg Bocharov
RMRoland May
Roland May
The current study is devoted to simulating cuttings transport by drilling fluid through a horizontal section of borehole with an annular cross section. Drill pipe rotates in fixed eccentric position. Steady-state flow is considered. Cuttings are rigid spheres with equal diameters. The carrying fluid is drilling mud with Herschel-Bulkley rheology. Suspension rheology depends on local shear rate and particles concentration. Continuous mixture model with algebraic equation for particles slipping velocity is used. Two hydrodynamic regimes are considered: axial flow without drill pipe rotation and with drill pipe rotation. In the case of axial flow was shown that increasing of power index n and consistency factor k increases pressure gradient and decreases cuttings concentration. Increasing of yield stress leads to increasing of pressure gradient and cuttings concentration. Cuttings concentration achieves constant value for high yield stress and not depends on it. Rotation of the drill pipe significantly changes the flow structure: pressure loss occurs and particles concentration decreases in the cross section. Two basic regimes of rotational flow are observed: domination of primary vortex around drill pipe and domination secondary vorticity structures. Transition between regimes leads to significant changes of flow integral parameters.

9 June 2019
Verified
Conference Paper
Closed access
PDF file
YIYaroslav Ignatenko
Yaroslav Ignatenko
AGAndrey Gavrilov
Andrey Gavrilov
OBOleg Bocharov
Oleg Bocharov
RMRoland May
Roland May
An Eulerian mixture model of the two-phase flow was used for cuttings transport simulation. The model was tested using experimental data for particles transport in pipes. Three types of problem statements were analyzed: steady-state flow, non-stationary flow in a short-length channel with periodic boundary conditions, and non-stationary flow in a long channel. Simulation of cuttings transport by Herschel-Bulkley fluid through an inclined 21-inch borehole/–6.5-inch drillpipe annulus was performed. All problem statements showed very close results, even for unsteady flow. These results demonstrated the applicability of 2D steady-state problem formulation for cuttings transport simulation. The unsteady flow was observed for an inclination of less than 20 degrees. Slow downward sliding of cuttings in the lower part of inclined boreholes was observed simultaneously with upstream dunes movement. Drill pipe rotation significantly decreased the cuttings concentration and pressure gradient, and shifted the maximum cuttings transport downward sliding rate from a 20- to 40-degree inclination.