David Lopez-Bueno

David Lopez-Bueno

Auto-generated profile, based on publicly available information

David Lopez-Bueno

Centre Tecnologic de Telecomunicacions de Catalunya (CTTC), Castelldefels, Spain

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2013
Verified
Conference Paper
Closed access
Pere L. GilabertPere L. Gilabert
Pere L. Gilabert
GMGabriel Montoro
Gabriel Montoro
DLDavid Lopez
David Lopez
NBNikolaos Bartzoudis
Nikolaos Bartzoudis
EBEduard Bertran
Eduard Bertran
AHAlain Hourtane
Alain Hourtane
This paper presents how to apply order reduction in wide-band digital predistortion (DPD) linearizers using the principal component analysis (PCA) technique. This method is tested in a wireless backhauling transmitter where four 28 MHz adjacent subcarrier transmission of M-QAM signals are considered. The DPD has to counteract not only the PA nonlinear behavior, but also its dynamics. This may results critical when considering wideband signals since the number of coefficients required to model memory effects can grow dramatically. By applying the PCA technique, the number of essential parameters can be significantly reduced. In addition, a strategy to minimize the computational cost of finding the optimal coefficients is also presented. A test-bed for evaluating the DPD linearization performance of the RF subsystem when PCA is applied was deployed and experimental results are presented in this paper.

1 October 2018 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Open access
DLDavid Lopez-Bueno
David Lopez-Bueno
QPQuynh Anh Pham
Quynh Anh Pham
GMGabriel Montoro
Gabriel Montoro
Pere L. GilabertPere L. Gilabert
Pere L. Gilabert
This paper presents an estimation/adaptation method based on the adaptive principal component analysis (APCA) technique to guarantee the identification of the minimum necessary parameters of a digital predistorter. The proposed estimation/adaptation technique is suitable for online field-programmable gate array or system on chip implementation. By exploiting the orthogonality of the resulting transformed matrix obtained with the APCA technique, it is possible to reduce the number of coefficients to be estimated which, at the same time, has a beneficial regularization effect by preventing ill-conditioning or overfitting problems. Therefore, this identification/adaptation method enhances the robustness of the parameter estimation and simplifies the adaptation by reducing the number of estimated coefficients. Due to the orthogonality of the new basis, these parameters can be estimated independently, thus allowing for scalability. Experimental results will show that it is possible to determine the minimum number of parameters to be estimated in order to meet the targeted linearity levels while ensuring a robust well-conditioned identification. Moreover, the results will show how thanks to the orthogonality property of the new basis functions, the coefficients of the digital predistorter can be estimated independently. This allows to tradeoff the digital predistorter adaptation time versus performance and hardware complexity.

3 August 2018 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Open access
QPQuynh Anh Pham
Quynh Anh Pham
DLDavid Lopez-Bueno
David Lopez-Bueno
TWTeng Wang
Teng Wang
GMGabriel Montoro
Gabriel Montoro
Pere L. GilabertPere L. Gilabert
Pere L. Gilabert
This paper presents a technique to estimate the coefficients of a multiple-look-up table (LUT) digital predistortion (DPD) architecture based on the partial least-squares (PLS) regression method. The proposed 3-D distributed memory LUT architecture is suitable for efficient FPGA implementation and compensates for the distortion arising in concurrent dual-band envelope tracking power amplifiers. On the one hand, a new variant of the orthogonal matching pursuit algorithm is proposed to properly select only the best LUTs of the DPD function in the forward path, and thus reduce the number of required coefficients. On the other hand, the PLS regression method is proposed to address both the regularization problem of the coefficient estimation and, at the same time, reducing the number of coefficients to be estimated in the DPD feedback identification path. Moreover, by exploiting the orthogonality of the PLS transformed matrix, the computational complexity of the parameters' identification can be significantly simplified. Experimental results will prove how it is possible to reduce the DPD complexity (i.e., the number of coefficients) in both the forward and feedback paths while meeting the targeted linearity levels.

7 December 2015 in IEEE Microwave Magazine
Verified
Journal Article
Open access
DLDavid Lopez-Bueno
David Lopez-Bueno
TWTeng Wang
Teng Wang
Pere L. GilabertPere L. Gilabert
Pere L. Gilabert
GMGabriel Montoro
Gabriel Montoro
Fourth-generation (4G) communication systems based on orthogonal frequency division multiplexing (OFDM) and the proposed backwards compatible fifth-generation (5G) variants, like filter-bank multicarrier (FBMC), are based on modulation techniques that allow significantly increased spectral efficiency and capacity in mobile radio access networks (RANs). However, the use of these modulation techniques impacts the requirements of the radio base stations, which have been traditionally the most energy-consuming element of mobile networks, accounting for up to 80% of the energy consumption of RANs [1]. Non-constant envelope-modulation techniques with high peak-to-average power ratios (PAPRs) require highly linear power amplifier (PA) amplitude and phase responses to fulfill stringent spectral mask and modulation accuracy requirements. This is often achieved with significant PA back-off, which considerably reduces PA efficiency because the PA's maximum efficiency is achieved near the saturation point.

3 July 2019 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
QPQuynh Anh Pham
Quynh Anh Pham
GMGabriel Montoro
Gabriel Montoro
DLDavid Lopez-Bueno
David Lopez-Bueno
Pere L. GilabertPere L. Gilabert
Pere L. Gilabert
This paper presents a new technique that dynamically estimates and updates the coefficients of a digital predistorter (DPD) for power amplifier (PA) linearization. The proposed technique is dynamic in the sense of estimating, at every iteration of the coefficient's update, only the minimum necessary parameters according to a criterion based on the residual estimation error. At the first step, the original basis functions defining the DPD in the forward path are orthonormalized for DPD adaptation in the feedback path by means of a precalculated principal component analysis (PCA) transformation. The robustness and reliability of the precalculated PCA transformation (i.e., PCA transformation matrix obtained off line and only once) is tested and verified. Then, at the second step, a properly modified partial least squares (PLS) method, named dynamic partial least squares (DPLS), is applied to obtain the minimum and most relevant transformed components required for updating the coefficients of the DPD linearizer. The combination of the PCA transformation with the DPLS extraction of components is equivalent to a canonical correlation analysis (CCA) updating solution, which is optimum in the sense of generating components with maximum correlation (instead of maximum covariance as in the case of the DPLS extraction alone). The proposed dynamic extraction technique is evaluated and compared in terms of computational cost and performance with the commonly used QR decomposition approach for solving the least squares (LS) problem. Experimental results show that the proposed method (i.e., combining PCA with DPLS) drastically reduces the amount of DPD coefficients to be estimated while maintaining the same linearization performance.

31 December 2015 in IEEE Wireless Communications
Verified
Journal Article
Closed access
OFOriol Font-Bach
Oriol Font-Bach
NBNikolaos Bartzoudis
Nikolaos Bartzoudis
XMXavier Mestre
Xavier Mestre
DLDavid Lopez-Bueno
David Lopez-Bueno
PMPhilippe Mege
Philippe Mege
TMTor Andre Myrvoll
Tor Andre Myrvoll
Filter bank multi-carrier (FBMC) is a candidate modulation scheme for 5G cellular mobile broadband networks. A specific domain where FBMC offers a clear advantage over other multicarrier solutions is the efficient occupancy of underutilized and fragmented spectrum. This is due to the rich spectral containment of the FBMC technology, which guarantees superior interference protection to the primary coexisting transmissions. These features of FBMC could play an important role in the economic delivery of 5G services in licensed and unlicensed bands. This article focuses on the public safety domain where existing professional mobile radio (PMR) users plan to add broadband services at the 400 MHz band, aiming to occupy the spectral holes left by current narrowband transmissions. In this respect an agile SDR broadband downlink FBMC system, aimed at exploiting unused licensed PMR spectrum, was developed and experimentally validated. The FBMC frame structure shared key similarities with the LTE specification. Two different SDR design methodologies were used to build the real-time baseband prototype. The level of interference protection offered by a broadband FBMC system to a coexisting primary narrowband PMR transmission was practically demonstrated and compared to that of an equivalent LTE system. This was made feasible by evaluating the performance of a PMR terminal under different mobile channels and FBMC waveform configurations. The applicability of this work to other 5G spectrum cohabitation scenarios is discussed. Finally, the article highlights the need to extend the SDR design paradigm in order to tackle the challenges of real-time baseband processing in 5G broadband cellular systems.