The ceramic membrane surfaces coated with cysteic acid were tested for efficacy and the fouling rate at constant crossflow velocities (CFV) and two transmembrane pressures (TMP). The crossflow mode was used during the filtration process to enable the membranes to perform for longer periods. The calculated variability and substance rejection were used to determine the performance of the membranes. In addition, cleaning in situ (CIP) was performed on the membranes to ensure that the flux recovery process was executed smoothly after each run. The current study uses ceramic microfiltration membranes to investigate the effectiveness of a 2600-ppm calcium carbonate solution and 260-ppm 4-nitrophenol extraction/removal from water samples. The concentrations of Ca2+ ions of the distinct concentration samples were reduced by 89–96% by non-coating and coating ceramic microfiltration membranes for a three-hour reaction time. At the end of the run, the concentration of the solution was at a TMP of 0.20 MPa with an efficiency of about 99.5% at t = 160 min with a sustainable flux.
(Pb(II)) is one of the heavy metals compounds founds in the industrial wastes that needs to be removed from treated wastewater. Emulsion liquid membrane (ELM) has been introduced as an emerging technology for advanced wastewater and water treatment. This emerging technology of treatment can be intensified by strategically adding the hydrophobic ionic liquid of [OMIM][PF6] and ({[BMIM]+ [NTf2]-) ionic liquid to organic membrane phase (O) to facilitate the industrial implementation of ELM with ionic liquid. The results show that with the use of 5% (V/V) [OMIM][PF6] ionic liquid has increased the removal efficiency to 70.37% in reaction time of 5 minutes and both the stability and extraction activity of ELM are enhanced (2–3 times greater than the ELM alone). The outcomes of this work can be extended to other heavy metal removal from industrial wastewater and water.
30 December 2025 in Journal of Studies in Science and Engineering
Industrial wastewater treatment techniques for pollutant removal have restrictions due to their high cost and low efficiency. The objective of this recent work is to develop high-performance nanocomposites to remove the bromothymol blue dye (BTB) from industrial wastewater. The nanocomposites developed and tested are composed of manganese oxide-titanium dioxide/Multi-walled carbon nanotubes (Mn/Ti/MWCNTs) nanoparticles of various concentrations. The synthesized nanocomposites have been characterized using X-ray diffraction (XRD), Energy-dispersive X-ray spectroscopy (EDX), and Field Emission Scanning Electron Microscopy (FESEM) techniques. Results show that the addition of metal oxide nanoparticles to the MWCNTs matrix significantly enhanced removal efficiency. The developed Mn/Ti/MWCNTs nanocomposite achieved 78% removal of BTB from industrial wastewater. The Mn-Ti/CNTs nanocomposite exhibits a removal enhancement of MWCNTs alone was 45% and 32% over TiO₂:MnO₂ nanocomposite. The results of the current study demonstrate that the hybrid nanocomposite offers efficient removal of BTB from dye industrial wastewater compared to nano elements alone.