In this article a review of low temperature (LT) (≤500 °C) process modules in view of 3-D sequential integration is presented. First, both the bottom device thermal stability and intermediate back end of line (iBEOL) versus thermal anneal and ns-laser anneal is determined, setting up the top device temperature fabrication process at 500 °C during a couple of hours. Then, the full LT process flow with process modules developed at 500 °C is exposed. Great progress and breakthrough for high performance (HP) digital stacked FETs has been made recently. Areas previously considered as potential showstoppers have been overcome: 1) efficient contamination containment for wafers with Cu/ultra low- k (ULK) iBEOL enabling their reintroduction in front end of line (FEOL) for top FET processing; 2) low-resistance poly-Si gate for the top FETs and solutions for improving gate-stack reliability; and 3) full LT raised source drain (RSD) epitaxy including surface preparation combined with SiCO 400 °C spacer and SPER junctions activation. Finally, the first functional nMOS and pMOS demonstration with a 500 °C thermal budget (TB) is highlighted.
To take fully advantage of Junctionless transistor (JLT) low-cost and low-temperature features we investigate a 475°C process to create onto a wafer a thin poly-Si layer on insulator. We fabricated a 13nm doped (Phosphorous, 10 19 at/cm 3 ) poly-silicon film featuring excellent roughness values (R max = 1.6nm and RMS=0.2nm). Guidelines for grain size optimization using nanosecond (ns) laser annealing are given.
For the first time, we propose a 3D-monolithic SRAM architecture with a local back-plane for top-tier transistors enabling local back-bias assist techniques without area penalty as well as the capability to route two additional row-wise signals on individual back-planes. Experimental data are extracted from a 14nm planar Fully-Depleted-Silicon-on-Insulator (FDSOI) $0.078\mu \mathrm{m}^{2}$ SRAM in order to properly model 3D top-tier cells. Simulations show this technique yields a 7% bitline capacitance reduction, a 12%/16% read/write access time improvement at $V_{DD}=0.8\mathrm{V}$ and a reduction of minimum operating voltage $V_{min}$ by 60mV at $6\sigma$ w.r.t. planar SRAMs.