1 March 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
The sub 100 µV voltage levels and sub 100 Hz frequency range makes the processing of most popular signal electroencephalograph (EEG) for brain functionality analysis, a complex task. The low frequency content of EEG (useful signals below 70 Hz) is commonly used for diagnosis of various brain related disorders making low-pass filter (LPF) a key block in front-end processing as noise reduction and resolution enhancement is crucial for precise recovery of these information. This paper is aimed to design reduced transconductance (Gm) based low power and small area CMOS LPF with cutoff frequency (fc) around 70 Hz. The proposed design is simulated using Cadence virtuoso tool and gives cut-off frequency of 72.958 Hz with low output noise of 3.0609 µV/√Hz and power consumption of 264.060 nW at operating voltage of 0.4 V. The simulation results show linearity of performance over -40 to 100 °C. Layout of circuit takes up area of 86.74×81.21 µm and post layout simulation shows 5% variation in power consumption as compared to pre layout simulations.
15 September 2024 in International Journal of Information Technology
1 December 2023 in International Journal of Power Electronics and Drive Systems (IJPEDS)
A new paired configuration of opposite polarity BJTs, the “complementary Sziklai pair” is introduced in the series of multi-BJT-based devices like Darlington and Sziklai pair, and its viability is tested in small-signal common emitter (CE) and common collector (CC) amplifier configurations. The Darlington and Sziklai both face the problem of poor frequency response at a higher frequency which is addressed by the proposed configuration. The proposed pair with CE amplifier holds class-A amplification property with a high voltage gain of 200.05, a high current gain of 11.62, wider bandwidth of 1.64 MHz, and a low THD of 1.29E-6%, hence supports the potential of wide applicability in analog communication. Similarly, the proposed pair with CC configuration produces approximately a unit current gain of 0.99 with wider bandwidth of 1.90 MHz and low THD of 1.76E-6%, therefore it can be used as a current buffer in a generalized current follower circuit. Conclusively, the device structure of this new BJT pair may be considered the third consecutive member of the series of Darlington pair and Sziklai pair. The layout of the proposed CE and CC amplifier occupy small areas of 158.30 μm2 (10.23×15.47 μm) and 141.16 μm2 (10.20×13.84 μm) respectively in 180 nm process technology.
23 May 2024 in Chemical Physics Letters
13 November 2023 in Indian Journal of Science and Technology
Objective: Objective of the manuscript is to introduce a novel idea of designing a small-signal common collector (emitter follower) amplifier with user-defined PSpice model of PNP Sziklai pair. Method: A circuit simulation program is developed on the PSpice simulation platform to design and study the proposed amplifier circuit. Small-signal AC equivalent circuit analysis authenticates the proposed amplifier design and selection of biasing components. The proposed amplifier is also implemented on Cadence Virtuoso Simulation software at 180nm technology to validate the design by performing its layout and post-layout simulation. Findings: The proposed circuit gives high current gain and smaller gain fluctuations (β) due to environmental parameter variations. The effect of variation in stage current gain of Sziklai pair components is observed under different operating conditions. Equivalent circuit analysis, noise performance, and the effect of temperature on the performance of the proposed circuit are widely discussed. Other possible circuit structures with a similar concept of design are also discussed as special cases. Highly stable amplifier current gain as well as device current gain, high amplifier voltage gain, device voltage gains below unity, and low harmonic distortion are prime features of proposed circuit. The problem of finding a matched pair of BJTs for the Sziklai pair is also addressed in the proposed design. The linear distortion-less operation of this circuit, combined with its very high current gain, makes it a suitable candidate for instrumentation amplifiers with wide operating frequency range. The proposed amplifier takes up (10.105 x 10.055) μm2 of area at 180nm technology. The results of pre-layout and post-layout AC responses show that there is a close resemblance between the parameters before and after the layout, which promotes the usability and design of the proposed amplifier. Novelty: The idea explored in the manuscript is entirely new and first time announced by authors. Keywords: PNP Sziklai Pair, Common Collector Amplifier, Current Gain, Small Signal Amplifier, Cadence Virtuoso
15 May 2026 in Journal of Circuits, Systems and Computers