Laboratory for Instrumentation, Biomedical Engineering and Radiation Physics, LA-REAL.NOVA School of Science and Technology, Campus FCT-UNL, 2829-516 Caparica, Portugal
Auto-generated profile, based on publicly available information
João Silva
Laboratory for Instrumentation, Biomedical Engineering and Radiation Physics, LA-REAL.NOVA School of Science and Technology, Campus FCT-UNL, 2829-516 Caparica, Portugal
Congenital limb defects occur when a limb does not develop normally during pregnancy. The quality of each person's everyday life is significantly impacted by any of these defects and there is no concrete treatment. 3D modeling and printing, enables the creation and customization of precise virtual and/or physical models, including models of the human anatomy. These technologies provide a novel method of producing new devices with optimized design and production time, improving adaptability, and incorporating functionality. To this end, we propose a method of designing and producing 3D printed assistive devices and we also present an example of an assistive device, done in the 3D Printing Center for Health, as well as its impact on the patient's daily life. With this device, the patient became able to play the guitar and hold a knife, thus helping on these two activities.
In this work we present a methodology for the non-destructive elemental determination of formalin-fixed paraffin-embedded (FFPE) human tissue samples based on the Fundamental Parameters method for the quantification of micro Energy Dispersive X Ray Fluorescence (micro-EDXRF) area scans. This methodology intended to overcome two major constraints in the analysis of paraffin embedded tissue samples - retrieval of optimal region of analysis of the tissue within the paraffin block and the determination of the dark matrix composition of the biopsied sample. This way, an image treatment algorithm, based on R® tool to select the regions of the micro-EDXRF area scans was developed. Also, different dark matrix compositions were evaluated using varying combinations of H, C, N and O until the most accurate matrix was found: 8% H, 15% C, 1% N and 60% O for breast FFPE samples and 8% H, 23% C, 2% N and 55% O for colon. The developed methodology was applied to paired normal-tumour samples of breast and colon biopsied tissues in order to gauge potential elemental biomarkers for carcinogenesis in these tissues. The obtained results showed distinctive biomarkers for breast and for colon: there was a significant increase of P, S, K and Fe in both tissues, while a significant increase of Ca an Zn concentrations was also determined for breast tumour samples.
The increasing popularity of macroalgae products highlights their potential as a safe source of essential macro and microelements for consumers. This study characterized wild and farmed macroalgae elemental composition and assessed the presence of biotoxins to identify potential health risks. Wild and farmed macroalgae samples were collected throughout 2024–2025, from three aquaculture production sites along the Portuguese coast (Ria de Aveiro, Matosinhos, and Olhão). Samples were freeze-dried, compressed and using a micro-XRF spectrometer, elemental composition was assessed. Macroalgae species factor was the strongest driver of elemental composition, explaining over 80% variation in macro and trace elements. Origin did not showcase statistical significance for elemental composition. Seasonal differences, though relatively small in extent, significantly impacted redox-sensitive elements in macroalgae, namely copper and manganese. All elements stayed below 30% of the recommended dietary recommendations, except iron (ranging from 0.5% to 111.8% of UL%) and Mn (ranging from 0.1% to 101% of UL%). All samples revealed the absence of regulated marine toxins. Only traces of the non-regulated cyclic-imine toxin SPX1 were detected in samples of Fucus vesiculosus. All quantified elements do not represent any risk for human health, strengthening the safety of macroalgae from the Portuguese coast.