The paper presents examinations of the surface of base concrete with a 3D scanner. Two base concrete surfaces, differently prepared, were examined, together with two measurement strategies: simple and fast 3D scanning and partial scanning in selected areas corresponding to the device measurement space. In order to complete the analysis of a concrete surface topography an original Matlab-based program TAS (Topography Analysis and Simulation) was developed for both 2D and 3D surface analyses. It enables data processing, calculation of parameters, data visualization and digital filtration.
This paper focuses on an analysis of the surface texture formed during precision machining of tungsten carbide. The work material was fabricated using direct laser deposition (DLD) technology. The experiment included precision milling of tungsten carbide samples with a monolithic torus cubic boron nitride tool and grinding with diamond and alumina cup wheels. An optical surface profiler was applied to the measurements of surface textures and roughness profiles. In addition, the micro-geometry of the milling cutter was measured with the application of an optical device. The surface roughness height was also estimated with the application of a model, which included kinematic-geometric parameters and minimum uncut chip thickness. The research revealed the occurrence of micro-grooves on the machined surface. The surface roughness height calculated on the basis of the traditional kinematic-geometric model was incompatible with the measurements. However, better agreement between the theoretical and experimental values was observed for the minimum uncut chip thickness model.
Ceramic endosseous implant coatings have gained esteem due to their favorable osteoinductive and osteoconductive properties. However, such a layer may be prone to failure under in vivo conditions, which necessitates its modification. The aim of the present study was to modify an electrodeposited hydroxyapatite (HA) coating on titanium (Ti) with ultrashort-pulsed lasers for the incorporation of the ceramic into the sample surface and the texturing of the metal surface. The obtained surface was planned for application on the endosseous implant surface to enhance osseointegration. To our knowledge, such laser modification of a HA coating has not been performed previously. Four different HA coatings were created (A-D). Each coating was conditioned with 4 different laser irradiations (1-4 to 4-4), carried out using different power, velocity and frequency settings. The surface features of the laser-irradiated coatings were analyzed. The laser modifications of the HA coatings resulted in 2 kinds of surfaces. Laser-induced periodic surface structure (LIPSS) texturing could be observed on quadrants 1-4 to 3-4, with parallel grooves and HA crystals melted and sintered into spherical structures. The 4-4 laser surface conditioning did not altered the needle-like morphology of the HA coating. The LIPSS-fusion modification decreased the water contact angle of the samples. The ultrashort-pulsed laser modification of the HA coating for regimes 1-4 to 3-4 resulted in the LIPSS texturing of the Ti surface with HA sinterization. Further biological analyses are necessary to evaluate the cell and tissue response to such laser-modified HA coating on Ti.