16 January 2014 in Optics Express
We demonstrated a novel fiber in-line Mach-Zehnder interferometer (MZI) with a large fringe visibility of up to 17 dB, which was fabricated by misaligned splicing a short section of thin core fiber between two sections of standard single-mode fiber. Such a MZI could be used to realize simultaneous measurement of tensile strain and temperature. Tensile strain was measured with an ultrahigh sensitivity of −0.023 dB/μɛ via the intensity modulation of interference fringes, and temperature was measured with a high sensitivity of 51 pm/°C via the wavelength modulation of interference fringe. That is, the MZI-based sensor overcomes the cross-sensitivity problem between tensile strain and temperature by means of different demodulation methods. Moreover, this proposed sensor exhibits the advantages of low-cost, extremely simple structure, compact size (only about 10 mm), and good repeatability.
15 February 2019 in Journal of Lightwave Technology
23 April 2019 in Journal of Lightwave Technology
An ultra-compact cascaded Fabry Perot (F-P) interferometer in fiber, which exhibits a high-visibility and enhanced detection limit, has been developed by chemical-assisted femtosecond laser micromachining. The reflection spectrum of cascaded F-P interferometer shows stronger and narrower resonance than single F-P cavity. The liquid RI measurement demonstrates that the wavelength sensitivity and the dip intensity sensitivity are ∼888 nm/RIU and -882 dB/nm/RIU, respectively; and the obtained detection limit is, $4.22\times 10^{-5}$ RIU in RI range 1.325-1.330, which is much better than that of single F-P cavity ( $10^{-3}$ RIU). Moreover, the gas pressure measurement demonstrates that the wavelength sensitivity is 2.86 nm/Mpa and the detection limit reaches $1.311 \times 10^{-2}$ Mpa in pressure range 1.5 Mpa-2.0 Mpa. The proposed in-fiber cascaded F-P interferometer will find potential applications in chemical and biological sensors, biomedical probes and low-cost care products.
1 January 2023 in Regenerative Biomaterials
Materials of different allogeneic or xenogeneic or autologous origins are widely used as soft-tissue fillers or structural scaffolds in the field of cosmetic surgery, while complications including prosthesis infection, donor site deformity and filler embolization have always been difficult problems for plastic surgeons. The application of novel biomaterials may bring in hopeful solutions for these problems. Recently, some advanced biomaterials, such as regenerative biomaterials can effectively promote the repair of defective tissues, which have been proven to have good therapeutic as well as cosmetic effects in cosmetic surgery. Therefore, biomaterials with active compounds have drawn significant attention for the tissue regeneration of reconstructive and esthetic treatment. Some of these applications have achieved better clinical outcomes than traditional biological materials. This review summarized recent progress and clinical applications of advanced biomaterials in cosmetic surgery.
4 January 2019 in Journal of Lightwave Technology
We demonstrate a novel method for producing whispering gallery mode (WGM) resonators on a microfiber using femtosecond laser two-photon polymerization technology. The typical resonance was observed by coupling the microresonator with a tapered fiber in a region where they were physically separated. Unlike conventional WGM devices, this photosensitive resin-based resonator was deposited on a microfiber, whereby the structural integration was improved. Resonance was experimentally demonstrated using two types of ring structures, i.e., circle and racetrack. The devices were successfully used for temperature measurements, achieving a maximum temperature sensitivity of 1.68 nm/ °C and a Q-factor of 1.9 × 103.