Lenneke H. Slooff

Lenneke H. Slooff

Auto-generated profile, based on publicly available information

Lenneke H. Slooff

ECN Solar Energy, Petten 1755LE, The Netherlands

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 November 2008 in Physica Status Solidi (RRL) – Rapid Research Letters
Verified
Journal Article
Closed access
PDF file
LSL. H. Slooff
L. H. Slooff
EBE. E. Bende
E. E. Bende
ABA. R. Burgers
A. R. Burgers
TBT. Budel
T. Budel
MPM. Pravettoni
M. Pravettoni
ABA. Büchtemann
A. Büchtemann

10 July 2018 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
ARAngèle Reinders
Angèle Reinders
RKRavi Kishore
Ravi Kishore
LSLenneke Slooff
Lenneke Slooff
WEWouter Eggink
Wouter Eggink
This paper discusses the opportunities and challenges of designing products using luminescent solar concentrator (LSC) photovoltaic (PV) technologies. The focus is on the integration of LSC PV technologies in PV modules, future products and buildings. It is shown that the typical material properties of LSCs — low cost, colorful, bendable, and transparency — offer a lot of design freedom. Two differently designed LSC PV modules with back contacted solar cells are presented including ray-tracing simulations and experimental results resulting from their prototypes. It is shown that the efficiency of a LSC PV module can be 5.8% with a maximum efficiency of 10%. Further the results of a design study which focused on product integration of LSC PV technologies are presented and discussed. In total 16 different and highly innovative conceptual designs resulted from this project, which were prototyped at scale to show their feasibility and integration features.

23 March 2005 in Advanced Functional Materials
Verified
Journal Article
Closed access
PDF file
LSL. H. Slooff
L. H. Slooff
JKJ. M. Kroon
J. M. Kroon
JLJ. Loos
J. Loos
MKM. M. Koetse
M. M. Koetse
JSJ. Sweelssen
J. Sweelssen

27 April 2006 in Journal of Solar Energy Engineering
Verified
Journal Article
Closed access
PDF file
LSL. H. Slooff
L. H. Slooff
RKR. Kinderman
R. Kinderman
ABA. R. Burgers
A. R. Burgers
NBN. J. Bakker
N. J. Bakker
JRJ. A. M. van Roosmalen
J. A. M. van Roosmalen
MSM. Schleusener
M. Schleusener
One of the major loss mechanisms in state of the art photovoltaic cells is spectral loss resulting from inefficient use of ultraviolet photons and the lack of absorption of infrared photons by the solar cell. For a Si solar cell, e.g., spectral losses alone result in over 55% loss of the energy of the solar spectrum. Converting the spectrum of the incoming light such that it has a better match with the absorption spectrum of the solar cell can reduce spectral losses, especially in the case of a small absorption band, such as for dye sensitized solar cells and polymer solar cells. In this paper it is shown that the ultraviolet response of a multicrystalline silicon solar cell and polymer solar cell can be enhanced by application of a polymer coating doped with a luminescent dye. An increase in the power conversion efficiency is obtained for coatings with luminescent dyes with an absorption onset <450 nm. Coatings with luminescent dyes that absorb at higher wavelengths give rise to lower power conversion efficiencies. When applied to a dye sensitized solar cell, a decrease in the cell performance is observed.

10 February 2014 in Physica Status Solidi (a)
Verified
Journal Article
Closed access
PDF file
LSLenneke H. Slooff
Lenneke H. Slooff
NBNicolaas J. Bakker
Nicolaas J. Bakker
PSPaul M. Sommeling
Paul M. Sommeling
ABAndreas Büchtemann
Andreas Büchtemann
AWArmin Wedel
Armin Wedel
Wilfried Van SarkWilfried Van Sark
Wilfried Van Sark

27 January 2014 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
LSL. H. Slooff
L. H. Slooff
SVS. C. Veenstra
S. C. Veenstra
JKJ. M. Kroon
J. M. Kroon
WVW. Verhees
W. Verhees
LKL. J. A. Koster
L. J. A. Koster
YGYulia Galagan
Yulia Galagan
Solar cells are generally optimised for operation under AM1.5 100 mW cm−2 conditions. This is also typically done for polymer solar cells. However, one of the entry markets for this emerging technology is portable electronics. For this market, the spectral shape and intensity of typical illumination conditions deviate considerably from the standard test conditions (AM1.5, 100 mW cm−2, at 25 °C). The performance of polymer solar cells is strongly dependent on the intensity and spectral shape of the light source. For this reason the cells should be optimised for the specific application. Here a theoretical model is presented that describes the light intensity dependence of P3HT:[C60]PCBM solar cells. It is based on the Shockley diode equation, combined with a metal–insulator–metal model. In this way the observed light intensity dependence of P3HT:[C60]PCBM solar cells can be described using a 1-diode model, allowing fast optimization of polymer solar cells and module design.