A novel wideband microwave frequency divider based on a single-loop optoelectronic oscillator (OEO) is proposed and demonstrated. The Mach-Zehnder modulator (MZM) in the OEO is biased at the carrier suppression point to generate the ±1st order optical sidebands by the input frequency and the oscillating frequency, which produces an intermediate-frequency (IF) signal at a photodetector. If the IF frequency is the half of the input frequency, optoelectronic oscillation is established, which outputs a RF signal with a frequency that is 1/2 of the input frequency. Because there are no filters incorporated in the OEO loop, the operation frequency range is broad. In a proof-of-concept experiment, the input signal with a frequency ranging from 12 to 20 GHz (or from 20 to 36 GHz) is successfully divided into 6 to 10 GHz (or 10 to 18 GHz). The maximum power ripple is 2.92 dB, and the phase noise improvement is 5.71 dB, which agrees well with the theoretical value.
We propose a linearly chirped microwave waveform (LCMW) generation scheme applying a stimulated Brillouin scattering (SBS)-based Fourier domain mode locked (FDML) optoelectronic oscillator (OEO). In this system, SBS-induced phase-modulation-to-intensity-modulation-conversion is adopted to build a microwave photonic filter, of which the pass-band can be rapidly tuned by adopting a high-order frequency sweeping modulation sideband as the optical carrier. Thanks to the frequency multiplication capability and the fast mode selection with a very narrow pass band, the proposed system can generate broadband LCMWs with a good frequency modulation linearity. Besides, the bandwidth, central frequency, duty cycle and repetition rate of the LCMWs can be easily adjusted to satisfy different radar applications. A proof-of-concept experiment is carried out. The results can soundly verify the feasibility as well as the flexibility of the proposed LCMW generation system.
7 July 2022 in IEEE Transactions on Microwave Theory and Techniques
A system for simultaneous measurement of micro-wave Doppler frequency shift (DFS) and angle of arrival (AOA) is proposed based on a silicon integrated chip. In the chip, two dual-drive Mach–Zehnder modulators (DDMZMs) with a microring resonator (MRR) inserted between them are integrated. When an external laser is coupled into the chip, it is first modulated by two echo signals via the first DDMZM and then goes through the MRR to introduce an optical phase shift to one of the first-order sidebands that falls into the resonance of the MRR. After being remodulated by the transmitted signal at the other DDMZM, the lightwave is coupled out from the chip and separated into two channels by an optical coupler. In each channel, a bandpass filter (BPF) is employed to select the upper and lower sidebands. By measuring and comparing the powers, frequencies, and phases of the beat signals in the two channels, the DFS (without direction ambiguity) and AOA can be acquired. Based on the proposed method, DFS within ±100 kHz at 10, 15, and 20 GHz is successfully estimated with a maximum error of ±0.028 Hz, and AOA measurement from 0° to 75° with errors less than ±1.53° is also realized.
12 June 2024 in IEEE Transactions on Microwave Theory and Techniques
A novel method for improving the quality of arbitrary periodic waveforms is proposed via injection-locking of an optoelectronic oscillator (OEO). A low-quality arbitrary periodic signal with its frequency spectrum discretized by its repetition frequency is injected into the OEO system. When its repetition frequency equals an integral multiple of the free spectral range (FSR) of the oscillation loop, the injection-pulling mechanism triggers mode-locking in the frequency domain. Consequently, each oscillation mode synchronizes with the relative discretized frequency component of the injected periodic signal, and the gain accumulation for each frequency mode is improved through the pulling mechanism of the injection-locking process. In a proof-of-concept experiment, this approach successfully generates linearly frequency-modulated waveforms (LFMWs) with different bandwidths, a three-level frequency hopping (FH) microwave waveform covering an FH range of 400 MHz, and a 100-Mb/s phase-coded microwave waveform, respectively. This utilization of the injection-locking mechanism within a low phase noise OEO significantly enhances the spectral purity of the produced arbitrary periodic microwave waveforms.
In this paper, a short-cavity-based optoelectronic oscillator (SC-OEO) is proposed and experimentally analyzed for different kinds of microwave signal generation. With the same frequency bandwidth and OEO gain conditions, the gain obtained for each mode in the SC-OEO is much larger than that in a long-cavity-based OEO, making it easier to achieve phase-locking state, then generating a stable microwave frequency comb (MFC), and realizing a self-mode-locking state. In the experiment, a self-fundamental mode-locking SC-OEO is realized, where an MFC with a free spectrum range (FSR1) of 36.38 MHz is generated in the range of 20 GHz. The corresponding temporal signal is a periodic square-wave signal with a period T1 of 27.47 ns, which is equal to the time delay of the OEO loop. Harmonic-locking SC-OEO with an FSR2 = 0.5FSR1 = 18.19 MHz is also achieved, generating a periodic square wave pulse with a period T 2 = 2T 1 = 54.94 ns. By increasing the system gain, the proposed SC-OEO can evolve from the self-mode-locking state into chaotic state to generate a chaotic microwave signal with an effective bandwidth of 11.76 GHz. The proposed SC-OEO also can work at single-frequency oscillation state with no filter, which generates a microwave signal of 13.4 GHz. The experimental analysis of the SC-OEO provides an effective way to further study the rich nonlinear dynamics characteristics and complex microwave signal generation of the OEO system.
Phase-stabilized frequency transfer via free-space optical (FSO) links is urgently demanded for high-precision frequency synchronization. However, intensity fluctuations and optical loss in FSO links significantly degrade synchronization precision. We demonstrate a stable frequency synchronization system with low phase noise over a 250-m FSO link. A 100-MHz signal generated by an oven-controlled crystal oscillator is phase-stabilized transferred based on phase-conjugate cancellation. In the FSO link, tip-tilt mirrors are used to suppress beam wander. Meanwhile, a voltage-controlled oscillator is used in the remote site to reduce the phase noise. The phase drift can be reduced from 150 ps to less than 1 ps. Since the phase-locked VCO is used, an ultra-low phase noise of -180 dBc/Hz @ 1 MHz offset is realized and the integrated timing jitter can be reduced to 0.62 ps. The long-term frequency stability and low phase noise may support the synchronization across coherent distributed systems.