12 June 2025 in Electrical Engineering
The phase-shifted full-bridge (PSFB) converter is a preferred topology for isolated DC-DC converters with medium to high power levels. It can be utilized in a variety of applications, preferably with a wide input and/or output range. The efficiency of the converter, as well as its power density, is important factors for modern applications in the automotive industry or renewable energy sources. New semiconductor components based on gallium-nitride (GaN), silicon-carbide, or older silicon MOSFETs, specially designed for resonant converters, together with suitable converter modifications, enable an increase in efficiency and switching frequency. Various auxiliary networks and snubbers extended the limited zero-voltage switching (ZVS) in the lagging leg of the converter. GaN FET enables the utilization of small output capacitances in the PSFB converter to achieve ZVS at low loads even without auxiliary circuits. The small R DS(on) enables the decrease of the conduction losses caused by the circulating current. The FB converter with a controlled rectifier and secondary side energy recovery snubber and the PSFB converter with a synchronous rectifier are compared by simulation for different operational conditions. Finally, a measurement is performed on a PSFB converter with a synchronous rectifier at reduced output power, using a different output rectifier as mentioned in the theoretical part. The experimental part highlights the partial or full achievement of ZVS at different load currents.
1 January 2026 in Power Electronics and Drives
Efforts to minimise the size and material usage of power converters are reflected in efforts to increase the switching frequency. The problem is that semiconductor switching losses are proportional to the switching frequency, so it is necessary to find ways to keep efficiency high at higher switching frequencies. Gallium nitride (GaN) transistors have made it possible to improve the parameters of many topologies due to a better figure of merit (FOM). Thanks to GaN technology, it is possible to increase the soft switching range in the inverter of phase-shift full-bridge (PSFB) converter and thus reduce switching losses. This paper addresses the selection of semiconductor transistors for a synchronous rectifier (SR) operating at 500 kHz. Based on mathematical calculations and simulation results in the programme PLECS, the converter was designed and measured under laboratory conditions. The paper highlights the advantages and challenges of using GaN transistors in SRs, which, when properly applied, enable lower losses and thus higher efficiency at a switching frequency of 500 kHz.