This paper presents the results of numerical and experimental study of a Ka-band relativistic Cherenkov oscillator with average diameter of the slow-wave structure D ≈ 2.6λ. (λ is a wavelength). The combined mode selection including the diffraction loss in the electron diode was applied. The high-current accelerator SINUS-200 provided the thin-walled annular electron beam in the range of voltages 350-420 kV and currents of 2.9-3.8 kA at pulsewidth of 10 ns. The generation of 2.5-3-ns pulses at the central frequency 36.4-36.8-GHz and 400-600-MW output microwave peak power was realized. The corresponding efficiency of 42% ± 5% in power conversion has been obtained.
Results of theoretical and experimental investigations into a relativistic backward wave oscillator with a modulating resonant reflector are generalized. The modulating resonant reflector is used to reflect a counter propagating wave and guide it toward an electron collector. It is shown that premodulation of the electron beam near the reflector may have a significant effect on the starting conditions of oscillation; selective properties of the oscillator; and its efficiency, which may reach 40% when a high-current beam is transported by a strong magnetic field. In the reduced magnetic fields that were employed in the pulsed-periodic regime and were 1.5–2.0 times lower than those at which cyclotron resonance with the counter propagating wave is observed, the oscillator efficiency (30–35% at a wavelength of 8 mm) is limited by position and velocity spreads of particles. Mechanical pulsewise frequency tuning within about 10% at a repetition rate of 1–50 Hz and a multigigawatt microwave power, as well as a rise in the power and energy of microwave pulses via an increase in the cross-sectional dimensions of the slow-wave structure, are demonstrated to be feasible.
A high-efficiency relativistic microwave source based on a backward wave oscillator (BWO) with a resonance reflector has been studied by experimental and numerical methods. The BWO is capable of generating 12-ns pulses with a carrier frequency of 9.93 GHz at an output radiation power of 0.75 ± 0.11 GW. For the BWO pumped by a high-current electron beam from a SINUS-6K accelerator, the regime with relatively high pulse-to-pulse stability is characterized by a 40% efficiency of power conversion.
A tunable-frequency low-magnetic-field relativistic microwave oscillator is realized experimentally based on a relativistic backward-wave tube with a modulating resonance reflector. The generated frequency is tuned mechanically by moving the oscillator slow-wave structure relative to the reflector. At fixed parameters of the corrugations and of the electron bunch, a frequency tuning range of about 14% measured between −3-dB (relative to the maximum peak generated microwave power) points is realized. The maximum pulse power of 3.4 ± 0.7 GW was obtained at a carrier frequency of 3.65 GHz in a magnetic field of 0.44 T.
An efficient microwave oscillator (320 MW and 7.9 GHz) that generates microwave pulses with a duration of 90 ns is developed using optimization of an electron-wave system and decompression of the longitudinal magnetic field with a maximum induction of 0.62 T in the region of an explosive-emission cathode and a lower field (0.36 T) with respect to cyclotron resonance in the slow-wave structure. In a packet (up to 10 ns) repetitively-pulsed (100 Hz) regime, the maximum conversion efficiency of the electron-beam power to microwave radiation is 27%. The mean energy of the radiation pulse (23 J) is about 18% of the pulse energy of high-voltage oscillator.
This article presents time-dependent numerical modeling of V-band relativistic orotron: a high-power microwave generator with a TM03 oscillation mode in an oversized (D/λ ∼ 2.7) electrodynamic structure and diffractive output in the TM02 mode. Single-mode operation of the oscillator is ensured by the cyclotron selection of the working axisymmetric mode, with simultaneous depression of competing non-axisymmetric modes by means of cutting longitudinal slits in the wall of the slow-wave structure. The simulated output microwave power is 350 MW with a power conversion efficiency of 31% when using a 3.6 kA, 310 keV electron beam transported in the 3.9 T magnetic field. The simulation employed 2.5D axisymmetric and 3D Cartesian versions of the KARAT code.