31 December 2024 in Journal of Ocean Engineering and Technology
This study compares four estimation methods for determining the roll damping ratio using a series of free roll decay tests conducted in a two-dimensional wave tank. Numerous studies have been performed to estimate the roll damping ratio of floating structures while considering nonlinear effects. In this work, a floating structure was tested at four initial roll angles to investigate the nonlinear behavior at large roll motions. The roll natural periods were determined using the Fast Fourier Transform and the peak-to-peak method applied to the time series of the free roll decay test. At initial roll angles below 10°, the roll damping ratios derived from the four methods exhibited similar results. However, at initial roll angles exceeding 10°, the results varied significantly across the methods, likely due to differences in their treatment of nonlinear viscous effects. This study examines the applicability of these methods for various initial roll angles and recommends the minimum roll angle and the number of rolling period required for accurate calculations from free roll decay tests. Further studies are needed to evaluate roll damping ratios for motions exceeding 10° while accounting for nonlinear viscous damping effects.
28 February 2021 in Journal of Ocean Engineering and Technology
20 October 2019 in Journal of the Society of Naval Architects of Korea
It is essential to reduce the Infra-red signature for increasing ship’s survivability in ship design stage. However the ship’s IR signature is quite sensitive to the maritime and atmosphere. Therefore, it is very important to select the marine meteorological data to be applied to the signature analysis. In this study, we selected the three meteorological sample sets from the population of the Korea Meteorological Administration’s marine environment data in 2017. These samples were selected through the two-dimensional stratified sampling method, taking into account the geopolitical threats of the Korean peninsula and the effective area of the buoy. These sample sets were applied to three naval ships classified by their tonnage, and then the IR signature analysis was performed to derive the Contrast Radiant Intensity (CRI) values. Based on the CRI values, the validity of each sample set was determined by comparing Cumulative Distribution Function (CDF), and Probability Density Function (PDF). Also, we checked the degree of scattering in each sample set and determined the efficiency of analysis time and cost according to marine meteorological sample sets to confirm the possibility of a probabilistic method. Through this process, we selected the standard for optimization of marine meteorological sample for ship IR signature analysis. Based on this optimization sample, by applying probabilistic method to the management of IR signature for naval ships, the robust design is possible.