13 December 2022 in IEEE Transactions on Power Electronics
Medium-voltage large-capacity dc transformer (DCT) is the key energy conversion link for building intelligent distribution grid. Increasing the voltage and capacity of single module in DCT can effectively improve the power density and reduce the system cost. Aiming at the integrated gate commutated thyristor (IGCT)-based high-capacity dc transformer (IGCT–HDCT), the asymmetric topology design and quasi-zero-loss switching composite modulation are proposed to achieve the construction of high efficiency and power density DCT. Through designing the snubber circuit and phase-shift ratio trajectory ingeniously, the zero-voltage switching- on and zero-current switching- off operation of the IGCT–HDCT can be maintained, which greatly reduces the switching loss and gives full play to the extremely low on -state loss characteristics of IGCT. Meanwhile, the full-range soft-switching operation (from no-load to full-load) can be achieved in the composite modulation without adding any auxiliary component. And the design of the snubber circuit is greatly simplified, which cannot only effectively limit the dv / dt and di / dt of power semiconductors, but also improves the power density and operating efficiency of IGCT–HDCT. Finally, the theoretical analysis of the proposed system solution is verified by building a 1.25 MW IGCT–HDCT engineering prototype, and the maximum operating efficiency reaches 98.6%–99.1%.
13 February 2019 in IEEE Access
3 June 2023 in Journal of Catalysis
9 October 2019 in IEEE Transactions on Power Delivery
20 December 2023 in IEEE Transactions on Power Electronics
Voltage-source-converter-based high-voltage dc transmission (VSC-HVdc) is widely applied in the fields such as offshore wind power transmission, and modular multilevel converter (MMC) is a common converter for it. The large capacitors and numerous devices in MMC limit its technical economics. In comparison, the multilevel dc-link converter with single-device-modules in series (abbreviated as MDC) proposed in this article may have advantages in terms of volume, as well as the potential in cost and efficiency. The single-device modules (SDM) solve the problems on both voltage sharing and floating supply. The current model of MDC is analyzed, and the commutating process in MDC is discussed in detail. The SDMs perfectly match with the characteristics of the quasi-soft switch in MDC, maintaining energy balance during operation without overvoltage or undervoltage. Finally, a high-power MDC prototype of 6.2 MVA is innovatively implemented and comprehensively tested to verify the theoretical commutation analysis and feasibility of the proposal. The research is helpful for promoting the application of MDC in VSC-HVdc, thus further improve the competitiveness of VSC-HVdc.