Resistance switching effects in metal/perovskite contacts based on epitaxial c-axis oriented YBa2Cu3O6+c (YBCO) thin films with different crystallographic orientation have been studied. Three types of Ag/YBCO junctions with the contact restricted to (i) c-axis direction, (ii) ab-plane direction, and (iii) both were designed and fabricated, and their current-voltage characteristics have been measured. The type (i) junctions exhibited conventional bipolar resistance switching behavior, whereas in other two types the low-resistance state was unsteady and their resistance quickly relaxed to the initial high-resistance state. Physical mechanism based on the oxygen diffusion scenario, explaining such behavior, is discussed.
Thin Y‐Ba‐CU‐O films were prepared in‐situ by low‐temperature codeposition on Al2O3 substrates. The temperatures during preparation did not exceed 600 °C. As a source of Ba the BaF2 was used. The zero resistance Tc values were higher than 84 K, Jc =4×104 A/cm2 at 4.2 K/OT. The Auger electron spectroscopy analysis has shown almost a homogeneous distribution of the film components throughout the film thickness. X‐ray diffraction revealed the presence of unoriented 1‐2‐3 phase besides BaF2 and CuO and, one undefined phase, which might be oxyfluoride compound.
1 November 1992 in Physica C: Superconductivity and its Applications
Hg-Ba-Ca-Cu-O films have been grown on CeO2/R-plane sapphire substrates using a two-step process. First, a 200 nm thick Ba-Ca-Cu-(O, F) precursor film was prepared by sequential evaporation, then Hg-Re-Ba-Ca-Cu-O pellets as a source of Hg-vapour were applied using heat treatment. The prepared films were continuous with sufficient adhesion to the substrate and a maximum zero-resistance critical temperature of TC0 = 118 K. The x-ray diffraction measurements of all the prepared films confirmed the Hg-1212 phase as well as the minor Hg-1223 phase in some cases. We found that the best results were obtained at the mercuration temperature of 775 °C and an optimal annealing time within the range 0.5-5 h. The superconducting properties of the films prepared under unsuitable conditions were mostly improved after annealing in oxygen atmosphere. Darker parts of the film exhibited a different surface morphology and the presence of the Hg-1223 phase in plate-like grains.