1 September 2007 in Journal of Applied Physics
We present the reverse-bias current-voltage and deep-level transient spectroscopy (DLTS) characteristics of a Ga0.90In0.10N0.033As0.967∕GaAs positive-intrinsic-negative photodiode (Eg=0.92 eV) and a trap-assisted tunneling model which considers generation-recombination and tunneling mechanisms. Using trap parameters obtained from the DLTS measurement, the model generates current-voltage characteristics of the photodiode, which were found to be in good agreement with experimental current-voltage curves at different temperature. The model also suggests that high dark current at low reverse-bias voltage is caused by the presence of traps which have low activation energy. Furthermore, it is predicted that approximately ten times reduction in the dark current can be achieved when the trap concentration of type H-1 (Ea=0.15 eV) is reduced by one order. On the other hand, a similar reduction in defect concentration of type H-2 (Ea=0.40 eV), which is nearer to midgap does not produce the same effect.
15 September 2017 in Progress in Photovoltaics: Research and Applications
A GaInP/Ga(In)As/GaNAsSb/Ge 4J solar cell grown using the combined MOVPE + MBE method is presented. This structure is used as a test bench to assess the effects caused by the integration of subcells and tunnel junctions into the full 4J structure. A significant degradation of the Ge bottom subcell emitter is observed during the growth of the GaNAsSb subcell, with a drop in the carrier collection efficiency at the high energy photon range that causes a ~15% lower Jsc and a Voc drop of ~50 mV at 1‐sun. The Voc of the GaNAsSb subcell is shown to drop by as much as ~140 mV at 1‐sun. No degradation in performance is observed in the tunnel junctions, and no further degradation is neither observed for the Ge subcell during the growth of the GaInP/Ga(In)As subcells. The hindered efficiency potential in this lattice‐matched 4J architecture due to the degradation of the Ge and GaNAsSb subcells is discussed.
27 September 2021 in Applied Physics Letters
An InP-based quantum cascade laser structure emitting at a wavelength of 13.6 μm is proposed and demonstrated. The active region is based on a diagonal transition and three-phonon-resonance design. A 5 mm long, 30 μm wide high-reflection coated device with a double channel ridge waveguide structure has shown a threshold current density of 3.0 kA/cm2, a dynamic range of 4.4 kA/cm2, a peak output power close to 1 W, and an average optical power up to 11.7 mW at 3% duty cycle, at 293 K. The laser shows a characteristic temperature T0 of 314 K and T1 of 336 K over a temperature range from 283 to 313 K.
18 July 2016 in Journal of Applied Physics
The relationship between growth temperature and the formation of periodic interfacial misfit (IMF) dislocations via the anion exchange process in InSb/GaAs heteroepitaxy was systematically investigated. The microstructural and electrical properties of the epitaxial layer were characterized using atomic force microscope, high-resolution x-ray diffraction, transmission electron microscopy, and Hall resistance measurement. The formation of interfacial misfit (IMF) dislocation arrays depended on growth temperature. A uniformly distributed IMF array was found in a sample grown at 310 °C, which also exhibited the lowest threading dislocation density. The analysis suggested that an incomplete As-for-Sb anion exchange process impeded the formation of IMF on sample grown above 310 °C. At growth temperature below 310 °C, island coalescence led to the formation of 60° dislocations and the disruption of periodic IMF array. All samples showed higher electron mobility at 300 K than at 77 K.
15 May 2006 in Journal of Applied Physics
GaAsSbN layers closely lattice-matched to GaAs were studied for application as the intrinsic layer in GaAs-based 1.3μm p-i-n photodetector. The GaAsSbN was grown as the intrinsic layer for the GaAs∕GaAsSbN∕GaAs photodetector structure using solid-source molecular beam epitaxy in conjunction with a radio frequency plasma-assisted nitrogen source and valved antimony cracker source. The lattice mismatch of the GaAsSbN layer to GaAs was kept below 4000ppm, which is sufficient to maintain coherent growth of ∼0.45μm thick GaAsSbN on the GaAs substrate. The growth temperature of the GaAsSbN layer was varied from 420–480°C. All samples exhibit room temperature photocurrent response in the 1.3μm wavelength region, with dark current density of ∼0.3–0.5mA∕cm2 and responsivity of up to 33mA∕W at 2V reverse bias. Reciprocal space maps reveal traces of point defects and segregation (clustering) of N and Sb, which may have a detrimental effect on the photocurrent responsivity.
3 November 2015 in Progress in Photovoltaics: Research and Applications