1 January 2021 in Solar Energy Materials and Solar Cells
11 February 2019 in IEEE Journal of Photovoltaics
The highest efficiency heteroepitaxial GaAs solar cells on Si have historically been grown in the p+/n polarity, which was preferred due to the decreased sensitivity of open-circuit voltage in such cells to threading dislocations. The n+/p polarity also has potential advantages due to the higher mobility of electrons than holes in GaAs, and most multi-junction solar cells in the literature are grown in this polarity. Here, we demonstrate n+/p GaAs solar cells on Si with a certified AM1.5G efficiency of 16.8%, approaching the best certified efficiency of 18.1% for p+/n cells in the literature. The high efficiency of our n+/p cells is primarily due to the short-circuit current density of 26.5 mA/cm2, which is significantly higher than prior p+/n record cells. The strong carrier collection results from the use of a highly transparent AlInP window layer, thin n+ emitter, and a relatively high minority electron diffusion length in the p-type base. The high quantum efficiency of these n+/p cells at wavelengths of 700–880 nm makes them promising for future triple-junction devices on Si, where the GaAs will serve as a middle sub-cell.
24 November 2024 in Solar Energy Materials and Solar Cells
8 November 2024 in IEEE Journal of Photovoltaics
We investigate (Al)GaAsP distributed Bragg reflectors (DBRs) on Si (001) to improve the quantum efficiency (QE) of 1.7 eV GaAsP solar cells in GaAsP/Si tandem devices. Samples were grown on Si (001) by molecular beam epitaxy and consisted of a 2.1 $\mu \mathrm{m}$ GaAsP/GaP buffer followed by a ∼2 $\mu \mathrm{m}$ DBR with 20 periods of GaAsP/Al x Ga 1- x AsP alternating layers. Two different DBR designs were studied with x = 0.4 and x = 0.8, both targeting a peak reflectance wavelength of 700 nm. The average threading dislocation density on the DBRs was 1.4 × 10 7 cm −2 , suitable for high-performance GaAsP cells. The reflectance profiles matched well to simulations, and the GaAsP/Al 0.8 Ga 0.2 AsP DBR had a significantly higher peak reflectance and reflectance bandwidth than the GaAsP/Al 0.4 Ga 0.6 AsP DBR due to the higher refractive index contrast. QE simulations of GaAsP cells showed an improvement of ∼1 mA/cm 2 in short-circuit current density with a DBR, which should enable a ∼5% relative efficiency boost in the GaAsP cell and superior current matching to a Si bottom cell in tandem devices.
17 April 2024 in IEEE Journal of Photovoltaics
We compare the performance of front-junction (FJ) and rear-heterojunction (RHJ) 1.9 eV GaInP solar cells grown on Si by molecular beam epitaxy. First, time-resolved photoluminescence showed a minority carrier lifetime of 11.7 ns for n -GaInP on Si, indicating a high tolerance to threading dislocations due to the low mobility of minority holes. GaInP solar cells were grown on both GaAs and Si substrates in FJ ( p -type absorber) and RHJ ( n -type absorber) configurations. The internal quantum efficiency (IQE) of FJ cells was identical on GaAs and Si substrates and showed high IQE-derived short-circuit current density $ J_{\rm{SC,IQE}} $ > 14 mA/cm 2 , suitable for high-efficiency multijunction cells, while RHJ cells showed diminished $ J_{\rm{SC,IQE}} $ < 11 mA/cm 2 due to limited diffusion length and high sensitivity to front-surface recombination. The RHJ cells on Si maintained a high open-circuit voltage ( $V_{\rm{OC}}$ ) of 1.292 V with threading dislocation density (TDD) of 1.0 $ \times $ 10 7 cm −2 , a similar $V_{\rm{OC}}$ value to FJ cells grown lattice-matched on GaAs. In addition, for a high TDD of 2.7 $ \times $ 10 8 cm −2 , RHJ cells had a $V_{\rm{OC}}$ of 1.223 V, greater than FJs with 10 $ \times $ lower TDD of 2.7 $ \times $ 10 7 cm −2 , which further shows the high dislocation tolerance of n-GaInP. The high $V_{\rm{OC}}$ , combined with the proposed work to boost IQE, could enable GaInP RHJs on Si for multijunction cell applications.