Pt dissolution has already been intensively studied in aqueous model systems and many mechanistic insights have been gained. Nevertheless, transfer of new knowledge to real‐world fuel cell systems is still a significant challenge. To close this gap, we present a novel in situ method combining a gas diffusion electrode (GDE) half‐cell with inductively coupled plasma mass spectrometry (ICP‐MS). With this setup, Pt dissolution in realistic catalyst layers and the transport of dissolved Pt species through Nafion membranes were evaluated directly. We observed that 1) specific Pt dissolution increased significantly with decreasing Pt loading, 2) in comparison to experiments on aqueous model systems with flow cells, the measured dissolution in GDE experiments was considerably lower, and 3) by adding a membrane onto the catalyst layer, Pt dissolution was reduced even further. All these phenomena are attributed to the varying mass transport conditions of dissolved Pt species, influencing re‐deposition and equilibrium potential.
Finding the optimum structure in porous transport electrodes (PTEs) for proton exchange membrane water electrolyzer anodes is one of the central current technological challenges. Both the structure of the porous transport layer (PTL) and its interaction with the catalyst layer are crucial in finding this optimum structure. In this regard, manufacturing the catalyst layer on top of a PTL as a structure‐building process must be understood to find improved transport electrode structures. This work presents a PTE tomography where the catalyst ink is directly processed on a PTL. The catalyst distribution of anodic PTEs is analyzed and compared via X‐ray microtomography and cross‐sectional imaging of embedded PTE samples. The majority of the catalyst lies within the first 100 µm of the PTE. Considering the penetration depth of the membrane, a maximum of 60% of the catalyst is effectively used. For the first time, a voxel‐based catalyst layer deposition model is created and analyzed that is based on simple assumptions in the deposition process. This deposition model fits very well with the previous tomographic analysis. In the future, this model will allow more profound insight into the manufacturing process and is an important prerequisite for a future optimum design of PTEs.
Bipolar interfaces located directly between a proton conducting membrane and an anion exchange ionomer based anode catalyst layer are investigated in membrane electrode assemblies for water electrolysis.
1 December 2022 in Journal of the Electrochemical Society
Integrating platinum-based recombination catalysts into proton exchange membrane water electrolysis systems effectively reduces the anodic hydrogen content. We studied the effect of the platinum loading of an interlayer close to the anode within the membrane on the anodic hydrogen in oxygen content. For the investigated Pt-loadings between 1 μgPt cm−2 and 140 μgPt cm−2, the results revealed that for a 110 μm membrane, 7 μgPt cm−2 were sufficient to allow a safe operation at cathode pressures up to 10 bar. A further increase of the Pt-loading did not significantly improve the reduction of the anodic hydrogen in oxygen content.
Pt dissolution has already been intensively studied in aqueous model systems and many mechanistic insights have been gained. Nevertheless, transfer of new knowledge to real‐world fuel cell systems is still a significant challenge. To close this gap, we present a novel in situ method combining a gas diffusion electrode (GDE) half‐cell with inductively coupled plasma mass spectrometry (ICP‐MS). With this setup, Pt dissolution in realistic catalyst layers and the transport of dissolved Pt species through Nafion membranes were evaluated directly. We observed that 1) specific Pt dissolution increased significantly with decreasing Pt loading, 2) in comparison to experiments on aqueous model systems with flow cells, the measured dissolution in GDE experiments was considerably lower, and 3) by adding a membrane onto the catalyst layer, Pt dissolution was reduced even further. All these phenomena are attributed to the varying mass transport conditions of dissolved Pt species, influencing re‐deposition and equilibrium potential.