27 February 2022 in Eastern-European Journal of Enterprise Technologies
This paper considers the influence of the technology to finish and strengthen compressor blade tips made of EP718-ID alloy on the characteristics of the surface quality, surface layer, and bearing capacity. Taking into consideration the special role of the finishing-strengthening treatment in the formation of the quality of the surface layer, various options for blade tip processing were investigated. The blade tips were shaped by high-speed line milling. The finishing-strengthening stage of tip machining included manual polishing and ultrasonic hardening operations with steel balls in various combinations. The basic regularities have been established in the formation of the roughness of tip surfaces, the maximum height of micro-irregularities, the surface microhardness, and the propagation depth of the hardened layer, depending on the combination of finishing-strengthening machining techniques. The results of tests are given for multi-cycle fatigue of blade batches treated according to various variants of the technological process. The efficiency of polishing the surface of the tip after strengthening treatment has been established. To restore the quality characteristics of the surface layer after polishing, it is proposed to perform repeated strengthening treatment. It is shown that the use of double deformation hardening technology with intermediate polishing at the finishing-strengthening stage of blade manufacturing makes it possible to increase the endurance limit from 320 MPa to 400 MPa while increasing durability. Technology for the finishing-strengthening stage of machining blades made from nickel alloys, characterized by significant viscosity, has been devised. It is shown that based on the criteria of minimum labor intensity of machining and maximum endurance of blades, it is effective to use double deformation hardening with steel balls in an ultrasonic field with intermediate polishing.
15 May 2026 in Cutting & Tools in Technological System
Monowheels, in which the disk and working blades constitute a single structure without detachable connections, are critically important components of new generation gas turbine engines for aviation and power engineering. The use of such structures allows to reduce the weight and increase the reliability of the units. However, errors in the shape of the functional surfaces of the blades that arise during mechanical processing lead to a decrease in the engine efficiency and an increase in fuel consumption. To ensure the accuracy of manufacturing the functional surfaces of the blades during the technological process, it is necessary to know the conditions under which cutting occurs. The work uses an approach based on the distribution of the entire range of cutting speeds into five speed oscillation zones. It was established that the third speed zone is the most unfavorable during milling of blades on multi-coordinate CNC machines. It is characterized by high-intensity vibrations, which worsens the quality of the machined surface and reduces the stability of the cutter. Their cause is regenerative oscillations, which are excited during machining by the trace left on the cutting surface by the accompanying free oscillation. The purpose of the study is to determine the influence of the axial depth of cut on the quality of the machined surface during milling in the third speed zone of vibrations. The results of the experiments showed that due to the peculiarities of up-milling with an axial depth of cut of ap = 1 mm, waviness on the machined surface is not formed, even in the presence of regenerative oscillations. The obtained data allow us to develop recommendations for the selection of cutting modes that minimize the amplitude of oscillations and ensure that the monowheel blades meet high operational requirements.