9 September 2020 in Journal of Materials Chemistry C
Progress in energy storage ceramics for applications has been of interest owing to their clean green nature and excellent ferroelectric/dielectric performances. In this study, lead-free Sm-doped 0.95BaTiO3–0.05Bi(Mg0.5Ti0.5)O3 (BT–BMT–xSm) relaxor ferroelectric ceramics were synthesized and confirmed to be an appropriate material for storage devices. After the introduction of Sm2O3 into BT–BMT ceramics, their hysteresis loops gradually shrank and became slender, which is beneficial to achieving high efficiency energy storage in ceramic capacitors. The maximum recoverable energy density for the BT–BMT–xSm (x = 0.03) sample reached 3.86 J cm−3 at normal temperature, and its corresponding energy efficiency reached 81.6%. Moreover, it was found from impedance spectroscopy that the breakdown field strength is related to the oxygen defect content in the samples. Ceramic samples with fewer defects have better insulation performance, which means that a high breakdown field strength will be obtained. With proper doping, enhanced relaxor behaviour and breakdown field strength were obtained to achieve excellent energy storage properties.
5 August 2021 in Journal of Materials Chemistry C
MXene-coated airlaid paper sensors were fabricated via the dip-coating technique, displaying high sensitivity (7.65 kPa−1), broad sensing range (300 kPa) and durability for human motion monitoring and 3D folded conformational change detection.
9 September 2021 in Journal of Materials Chemistry C
The new effects induced by light in materials have important potential applications in optoelectronic multifunctional electronic devices. In this work, double perovskite oxide Bi2FeCrO6 (BFCO) thin films were prepared by the sol–gel method, and the structural, optical, and electrical transport properties were investigated in detail. Good and stable resistive switching (RS) behavior with a large ROFF/RON ratio (>60) at a small voltage of 0.5 V can be realized. Interestingly, optical modulation conversion of the RS behavior and a negative differential resistance (NDR) effect induced by light were found in the Au/BFCO/FTO devices. Furthermore, the mechanisms of the RS behavior, NDR effect, and carrier dynamics induced by light for the Au/BFCO/FTO devices were discussed; the formation of oxygen vacancies was proposed to explain the good and stable RS performance, and the effective separation of photogenerated carriers can result in the NDR effect, which is further confirmed by transient absorption spectroscopy. The conversion of RS memory and the NDR effect have potential applications in optical modulation multifunctional electronic devices, electronic information, and optical quantum computers.
16 October 2023 in Applied Physics Letters
Pulse power has many important technological applications, for which the dielectric capacitors are essential. It is imperative to understand the breakdown mechanism to improve the dielectric energy storage density, yet the breakdown process involves multi-physical coupling spanning multiple spatial and temporal scales, making its characterization very challenging. Recognizing local field concentration results in local strain concentration through Maxwell's stress, we develop an effective method to visualize the dielectric breakdown process via optic strain measurement. Utilizing high-performance biaxially oriented polypropylene as a demonstration, we find dielectric breakdown is an ultrafast process with breakdown current rising and dropping in just tens of nanoseconds. Rapid temperature rise is observed after breakdown as well due to Joule heating, though both current measurement and temperature mapping offer little insight before breakdown actually occurs. Nevertheless, substantial strain concentration is observed before breakdown, reflecting electric field concentration that eventually leads to breakdown. A well-defined upper bound on the electric field concentration is also noted.
1 March 2023 in JOURNAL OF SHENZHEN UNIVERSITY SCIENCE AND ENGINEERING
With the continuous development of urban rail transit in China, the line operating mileage is gradually increasing, and the line condition also changes from single point attendance to multi-point attendance. In the view of multi-point attendance and multiple parking lots on urban rail transit, drivers will have some preferences, such as a preference to exit at a certain point of attendance or not wanting to make a night transfer from a depot to another. To solve this problem, we propose three preferences that affect drivers' work efficiency and happiness under the condition of multi-point attendance, including rotation preference, night-morning continuous task preference and attendance point preference, and hence construct preference-oriented crew rostering optimization model for urban railway transit. Taking Shanghai Metro as an example, the proposed model is fully tested. It is proved that the model is effective for the above problem. It also shows certain advantages compared with the traditional manual programming method in the demand of rotation leave, the allocation of night and morning break time and the demand preference allocation of attendance points, which provides research basis for urban rail transit crew rostering problem.