This article reviews current research and development as well as future opportunities for packaging and antenna integration technologies for silicon-based millimeter-wave phased arrays in emerging communication applications. Implementations of state-of-the-art silicon-based phased arrays below 100 GHz are discussed, with emphasis on array architectures for scaling, antenna integration options, substrate materials and process, antenna design, and IC-package codesign. Opportunities and challenges to support phased array applications beyond 100 GHz are then presented, including emerging packaging architectures, interconnect characterization requirements, thermal management approaches, heterogeneous integration of multifunction chiplets, and novel antenna technologies.
20 May 2019 in IEEE Transactions on Microwave Theory and Techniques
Silicon-based millimeter-wave (mm-wave) phased-array technologies are enabling directional wireless data communications at Gb/s speeds. In this paper, we review and discuss the challenges of implementing a multichip phased-array antenna module for mm-wave applications using organic buildup substrate technology. A prototype test vehicle has been fabricated and studied to evaluate the antenna and interconnect performance, dielectric properties, package substrate warpage conditions at different temperatures, chip- and board-level joint process reliability, and thermal management feasibility for cooling. Based on the learning from the test vehicle, an organic-based multilayered phased-array antenna package for 28-GHz mm-wave radio access applications is implemented. The package incorporates 64 dual-polarized antenna elements and features an air cavity common to all antennas. Direct probing measurements on a single-antenna element of the package show over 3 GHz of bandwidth and 3-dBi gain at 28 GHz. A phased-array transceiver module has been developed with the package; the module includes four SiGe BiCMOS ICs attached using flip-chip assembly. Module-level measurements in the TX mode show a 35-dB near-ideal output power increase for 64-element power combining; 64-element radiation pattern measurements are reported with a steering range of ± 50° without tapering in off-boresight directions, and 64-element radiation pattern measurements with tapering show achievement of a sidelobe level lower than -20 dB. The transceiver modules achieved 20.64-Gb/s throughput with 256 QAM and 800-MHz bandwidth in direct over-the-air link measurement results.
27 September 2022 in IEEE Journal of Solid-State Circuits
We present a 24–30-GHz 256-element dual-polarization transceiver (TRX) phased array based on a 16-element beamformer integrated circuit (BF-IC), 2-element frequency conversion integrated circuit (FC-IC), liquid crystal polymer (LCP)-based combiners and filters, and a tileable package with 64 embedded dual-polarized (dual-pol) antennas. The phased array presented in this work overcomes three key challenges in current 5G millimeter-wave (mmWave) antenna arrays: 1) it supports a dramatic increase in the number of supported fast-access beams; 2) it offers improved power efficiency; and 3) it provides a path to lower solution cost. 1) We enable fast switching among $>$ 30 000 beams—orders of magnitude improvement over prior work—by employing an on-chip beam calculator in the BF-IC, achieving 200-ns beam setup and 8-ns over-the-air (OTA)-switching time. 2) We enable a module-level transmitter (TX) mode peak power added efficiency (PAE) of 20% using a modular architecture that preserves power amplifier (PA) linearity and efficiency as well as receiver (RX) mode low noise amplifier (LNA) noise figure (NF). The module achieves Psat effective isotropically radiated power (EIRP) of 68.5 dBm and BF-IC NF $<$ 3.9 dB. 3) We lower the solution cost by enabling a wider steering range to reduce the number of phased arrays required in a sectorized coverage scheme, by reducing the IC and package area, and by avoiding calibration. The wider steering range is enabled by using an in-package magnetoelectric dipole antenna (for the first time in silicon-based phased arrays), resulting in steering over $\pm$ 70 $^\circ$ in H-and V-pol in both E-and H-planes without requiring any calibration. Moreover, the module achieves $>$ 20-dB cross-polarization isolation across the entire $\pm$ 70 $^\circ$ beam steering range.
8 April 2021 in IEEE Microwave and Wireless Components Letters
This work introduces a multi-layered organic package with embedded antennas that enables the integration of a scalable wide-band phased array module supporting the n257, n258, and n261 5G frequency bands (24.25–29.5 GHz). The package comprises (1) an 8×8 array of dual-polarized antenna elements with 5.1-mm spacing, (2) RF, IF, DC, and digital interconnects to support RFICs, filters and combiners, and (3) a ball-grid array; it is implemented in a compact 42.5 mm×42.5 mm×1.65 mm form factor. The design achieves wideband operation with minimal cost or complexity overhead (e.g. air cavities or additional substrates) by integrating a novel magneto-electric dipole antenna in the package. Direct probing and radiation pattern measurements of three antenna variants in two prototype antenna array packages demonstrate > 6-GHz bandwidth with 0-5 dBi gain. Measurement results for associated liquid crystal polymer-based band-pass filters and power combiners are also presented.
23 October 2019 in IEEE Journal of Solid-State Circuits
In this paper, we present the design, assembly, and test of a heterogeneously integrated dual-polarized 256-element 5G phased array covering 24 $-$ 30 GHz. The design is based on a 64-element antenna-in-package tile designed using an organic substrate. This work represents one of the earliest examples of a heterogeneously integrated mmWave phased array module where each tile uses chips in three different substrate technologies to perform beamforming, frequency conversion, filtering, combining/splitting, and supply decoupling functions. The paper discusses the several challenges and system trade-offs for 5G mmWave phased arrays and illustrates the advantages of heterogeneous integration at the antenna-in-package level. The paper also covers, in detail, several practical aspects of phased array module design that are not well-described in existing literature, such as power domain modeling, module assembly, antenna feedline design, polarization isolation, and tile spacing. To demonstrate the efficacy of our design choices and techniques, we present exhaustive $\pm 360^\circ$ over-the-air beam characterization of the phased array antenna module demonstrating beam scanning over $\pm 70^\circ$ and very low cross-polarization leakage in E-/H-planes in both polarizations and in both TX and RX modes.