2 March 2015 in Applied Physics Letters
A dielectric-filled magnetically insulated transmission line oscillator (DFMILO) is presented in this paper, which introduces a low-loss dielectric to fill its resonant cavities and thus improves its technical performances. The fundamental mode frequency of the DFMILO is derived and its dispersion curve is analyzed. In simulation, high-power microwave is generated from the DFMILO with peak power of 3.1 GW, frequency of 1.467 GHz, and peak power conversion efficiency of 14.0% when the voltage is 455 kV and the current is 48.7 kA. However, the peak power conversion efficiency of the relevant unfilled MILO is only 8.5%. The comparative result shows that the filled dielectric helps to enhance the power conversion efficiency of the DFMILO. In addition, the filled dielectric contributes to decrease the MILO's dominant frequency, which means that if the dominant frequency is same, the volume of the DFMILO (especially the low-frequency DFMILO) is more compact than that of the relevant unfilled MILO.
1 June 2018 in Bioresource Technology
27 June 2019 in IEEE Transactions on Plasma Science
In order to improve power efficiency, a high-efficiency magnetically insulated transmission line oscillator (MILO) with ridge-disk-loaded vanes is proposed in this paper. Theoretical analyses show that slow wave structure (SWS) with ridges can improve the coupling impedance of MILO markedly, which thus increases the power efficiency of MILO. The proposed MILO with ridges is optimized with CHICPIC particle-in-cell code, and the simulation results are consistent with the theoretical results. In simulations, when the applied voltage and input power are 566 kV and 28.4 GW, the output power and maximum electric field of MILO with ridges are 6.0 GW and about 0.61 MV/cm, respectively. Moreover, the corresponding power efficiency reaches up to 21.0%, and the microwave frequency is 1.48 GHz. However, for the MILO without ridges, the output power and the power efficiency are only 5.0 GW and 17.6%, respectively, with the same input voltage and power, and the microwave frequency is 1.53 GHz. Therefore, the power efficiency of MILO with ridges increases by 19% in comparison to MILO without ridges.
18 January 2023 in IEEE Transactions on Electron Devices
Relativistic magnetron (RM) is a promising high-power microwave (HPM) source and major hotspot in the field of HPM research, whose advantages include high efficiency, low magnetic field, and compact configuration. A ${C}$ -band RM with a novel extraction structure is presented and investigated numerically in this article. Compared with the traditional ${C}$ -band RM with rectangular extraction slots (CRMRS), the ${C}$ -band RM with novel extraction slots (CRMNS) has three advantages. On the one hand, mode competition is suppressed effectually, and so its operation is more stable. On the other hand, the power efficiency is enhanced. Moreover, the power capacity is enhanced, which is advantageous to increase the output power. The typical simulation results are as follows: HPM is generated with a peak power of 2.53 GW at an efficiency of 58% and a frequency of 4.3 GHz, when the voltage is 650 kV, the current is 6.7 kA, and the magnetic field is 0.347 T.
3 February 2021 in IEEE Transactions on Microwave Theory and Techniques
In this study, we investigate the effect of including ridged disk vanes on the operation of a magnetically insulated transmission line oscillator (MILO) in an experiment using a comparison of a ridged MILO (RMILO) with a conventional MILO (CMILO). The only technical difference between the two models is the presence of ridges in the RMILO. The experimental results show that when the voltage is 486 kV and the current is 51 kA, the RMILO's peak microwave power is approximately 2.9 GW with a pulse duration of more than 35 ns and a microwave frequency of approximately 1.48 GHz. In contrast, the CMILO has the highest power microwave with a peak power of 2.1 GW corresponding to a pulse duration of more than 40 ns and a microwave frequency of approximately 1.53 GHz. The RMILO's power efficiency increases to 11.7%, a 25% increase compared to that of the CMILO under the same conditions. The experimental measurements exactly coincide with the simulation results. Thus, including ridged disk vanes produces a superior performance.
16 March 2023 in IEEE Transactions on Electron Devices
In the present study, the frequency tunability of a magnetically insulated transmission line oscillator (MILO) is investigated by simulation in conjunction with an experiment. In the simulation, the tunable MILO reaches a maximum output power of approximately 5.0 GW with an applied voltage of 590 kV and an input power of 29 GW. The corresponding power efficiency is 17.2%, and the frequency is 1.575 GHz. In addition, by adjusting the outer radius of the vane from 77 to 150 mm, the 3-dB tunable frequency of the tunable MILO ranges from 0.85 to 2.12 GHz, and the tuning bandwidth is 85.5%. The experimental results show that when the voltage and current are 405 kV and 42 kA, respectively, the peak microwave power of the tunable MILO is approximately 2.3 GW with a microwave frequency of approximately 1.900 GHz. The difference in the two frequencies at the peak microwave power is significant because of the tuning mechanism. When the outer radius of the vane varies in the range of 76.6–93.0 mm, the 3-dB tunable frequency range is between 1.552 and 2.168 GHz, corresponding to a 3-dB tuning bandwidth of 33.1%. The experimental measurements verify the simulation results.