Nachiketa Deshmukh

Nachiketa Deshmukh

Auto-generated profile, based on publicly available information

Nachiketa Deshmukh

Department of Electrical Engineering, Indian Institute of Technology Kanpur, Kanpur, India

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 December 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
AAAnup Anurag
Anup Anurag
NDNachiketa Deshmukh
Nachiketa Deshmukh
AMAvinash Maguluri
Avinash Maguluri
SASandeep Anand
Sandeep Anand
Owing to low cost, small size and low weight, transformerless inverters became prominent in single-phase grid connected photovoltaic systems. Key issues pertaining to these inverters include suppression of common mode leakage current and improvement of conversion efficiency. Achieving higher efficiency in single-phase grid-connected photo-voltaic systems depends on the number of stages involved in feeding power to the grid, predominantly, if the photovoltaic (PV) array voltage is less than peak value of the grid voltage. In this paper, an integrated dc-dc converter based grid-connected transformerless PV inverter is proposed which is aimed at maintaining a high efficiency even if the PV array voltage falls below the peak value of grid voltage (efficient operation at an extended input voltage range). A modulation strategy is discussed in order to minimize the flow of common-mode leakage current. Further, the efficiencies of certain transformerless inverter topologies are analyzed and compared with that of the proposed topology. Detailed simulation studies are carried out in MATLAB/Simulink environment to verify the analysis. Experimental results for a scaled down laboratory prototype are included as a proof-of-concept to validate the claims.

18 September 2020 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
NDNachiketa Deshmukh
Nachiketa Deshmukh
SPSiva Prabhakar
Siva Prabhakar
SASandeep Anand
Sandeep Anand
Active Power Decoupling (APD) circuits enable the use of long lifetime capacitors (film or ceramic capacitors) in single phase power converters. Owing to the inclusion of the APD circuits, the literature reports (1.5 to 1.8)% drop in efficiency of single phase converter at rated power. This reduction in conversion efficiency is one of the significant challenges in the practical use of APD circuits. This paper proposes an approach to reduce the power loss in the bidirectional buck converter based APD circuit. This approach is presented with the help of analytical calculations and graphical representation of operation of APD circuit. The proposed approach requires rapid variation in the average voltage of the buffer capacitor with a change in inverter power. To achieve this, an enhanced control technique is suggested with a duty ratio injection controller. The steady state and transient response of the proposed control technique is validated with simulation and experimentation. Further, the reduction in power losses realized by the proposed approach is verified with the help of a developed laboratory prototype. The proposed approach obtains up to 1% improvement in efficiency of single phase converter at rated power, when compared with existing APD approaches.

14 June 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
Arnab SarkarArnab Sarkar
Arnab Sarkar
NDNachiketa Deshmukh
Nachiketa Deshmukh
SASandeep Anand
Sandeep Anand
The recently proposed independently controlled multiple output flyback converter (ICMOFC) scheme improves cross-regulation by utilizing gallium nitride (GaN) switches with negative gate turn- off voltage. The highly inefficient reverse conduction (RC) of negative gate biased GaN devices leads to significant RC loss in the existing ICMOFC scheme. To mitigate this problem, this letter proposes a new pulsewidth modulation (PWM) scheme. The RC loss reduction is achieved by reducing the RC duration and RC current. The effectiveness of the proposed PWM strategy is analytically and experimentally verified using a 40-W dual output flyback converter. The results demonstrate a peak efficiency improvement of 1.26% over the existing ICMOFC scheme. Furthermore, the scheme also achieves high power density (51 W/in $^{3}$ ) and excellent cross-regulation (0.2%).

3 July 2023 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
ACAbhishek Chanekar
Abhishek Chanekar
NDNachiketa Deshmukh
Nachiketa Deshmukh
AAAbhinav Arya
Abhinav Arya
SASandeep Anand
Sandeep Anand
Active thermal control (ATC) is popularly used for the reduction of junction temperature swings and for enhancing the reliability of power semiconductor devices (PSDs). Gate voltage variation has the potential to be an effective method for ATC by manipulation of power loss in the PSD. However, gate voltage variation in the ohmic region of static I-V characteristics does not change the power loss in PSD significantly. To address this challenge, this article proposes an ATC technique based on gate voltage variation in the saturation region of PSD. With the proposed controller, a wide range of power loss manipulation is achieved. Moreover, it avoids false triggering of desaturation protection through a suitable selection of gate voltage. The relationship between gate voltage and power loss in PSD is derived and found to be nonlinear in nature. The proposed controller compensates for this nonlinearity to achieve smooth control over the power loss in PSD. The simulation and experimental validation of the proposed controller are carried out on a laboratory prototype of a dc–dc buck converter for battery charging application. Using the proposed controller, a lifetime improvement of 43% is estimated for a typical mission profile.

11 July 2022 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
NDNachiketa Deshmukh
Nachiketa Deshmukh
ACAbhishek Chanekar
Abhishek Chanekar
SASandeep Anand
Sandeep Anand
SSSoumya Ranjan Sahoo
Soumya Ranjan Sahoo
Aluminum electrolytic capacitors (AECs) and power semiconductor devices (PSDs) are typically identified as weak links in the reliable design of power converters. To eliminate the AECs from the design, active power decoupling (APD) circuits are preferred in single-phase power converters. However, in an attempt to eliminate AECs, this approach introduces the latter weak link in the design, i.e., PSDs in the APD circuit. This article proposes an active thermal control technique to improve the reliability of PSDs in the buck APD circuit. The proposed technique reduces the swing in junction temperature of PSDs using noninvasive power loss modulation. The power loss in PSDs is changed by varying the average voltage across the buffer capacitor. Further, a control technique is suggested to synthesize the reference for average voltage across buffer capacitor. This controller accounts for nonlinearities and minimum/maximum limits of power loss modulation. Further, the additional energy loss due to power loss modulation is restricted to a predefined limit. The proposed technique is validated with the help of circuit simulations and experimental studies with a 500 W laboratory prototype. For the selected mission profile, an increase of 28.5% in the lifetime of PSDs in buck APD circuit is estimated.

1 October 2015
Verified
Conference Paper
Closed access
NDNachiketa B. Deshmukh
Nachiketa B. Deshmukh
RTRaosaheb D. Thombare
Raosaheb D. Thombare
PJPravin T. Jadhav
Pravin T. Jadhav
DMDagadu S. More
Dagadu S. More
Renewable energy resources have astonishing capabilities to fulfill ever increasing future demands if utilized properly. Changing climatic conditions is a major inherent drawback associated with it and MPPT (Maximum Power Point Tracking) is one of the techniques used to overcome it (wind and solar). This paper has proposed a negative output super lift Luo converter which is integrated with multiple sources for reducing passive elements. The proposed MISO (Multiple Input Single Output) topology can be used for low or high power applications and can be extended to interface any number of sources having different characteristics. In case used for renewable sources' grid integration, it can extract maximum power from each source with its own MPPT controller. It also has a bidirectional battery storage port that improves reliability of the system. These systems are simulated in MATLAB software environment and results are obtained.