10 April 2018 in IEEE Transactions on Industry Applications
This paper proposes a comprehensive evaluation of stacked revenue generated from grid-connected energy storage systems (ESSs). The stacked revenue from an ESS cannot be calculated by merely aggregating the benefits from various applications (e.g., energy arbitrage, frequency regulation, and outage mitigation) as the ESS may not be available for all types of applications during the same time interval---because a quantity committed to one market may not be committed to another. In this paper, different types of applications for grid-connected ESSs are identified, and a model incorporating component reliability, power system operation constraints, and storage system operation constraints is developed to evaluate the composite revenue generated from these applications. In this model, the types of applications of ESSs are prioritized according to their intended contributions and system operating conditions. Sequential Monte Carlo simulation is used for evaluating value from the reliability improvement and a quadratically constrained linear programming model is built for estimating the maximum revenue from arbitrage and regulation markets. The proposed method is demonstrated on the IEEE reliability test system (IEEE-RTS) with the historical PJM data.
21 May 2018 in IEEE Transactions on Industry Applications
The integration of wind power into the grid causes numerous stability and reliability issues due to its low inertia and intermittent nature. To ensure system stability, wind power production has to be restricted, which implies that the system cannot absorb the entire output available from wind generation, especially if the output is high. Consequently, the reliability of the integrated system is adversely affected. In order to improve the system reliability, energy storage can be used, which is emerging as a prominent solution for enhancing supply continuity. Complete utilization of an energy storage device can be achieved if it is properly coordinated with wind and conventional generation. This paper proposes a new method to coordinate energy storage with the existing system to improve the system reliability while maintaining the system frequency security. The effectiveness of the model is demonstrated on the IEEE RTS-79 system.
2 September 2019 in IEEE Transactions on Industry Applications
Optimal power flow (OPF) minimizes the production cost while satisfying the constraints of the system, including real and reactive power balance, equipment capability constraints, and voltage limits. This paper presents a method of including a frequency security constraint within the framework of the OPF problem. Increasing displacement of conventional generation by renewable resources that contribute little or no frequency regulation capability may necessitate the enforcement of such a constraint to meet frequency security requirements. The system frequency is required to be maintained within a safe limit, thus indicating the balance between generation and consumption. Hence, the solution for optimization of power flow should not only present a minimum cost of generation within the operating conditions, but also ensure frequency stability. In order to obtain this solution, the requirement of frequency stability is introduced as a new constraint of the power dispatch problem and is represented by the maximum frequency deviation limit. This new constraint is constructed as a non-linear function of system inertia and the frequency regulation constant, since frequency deviation is highly sensitive to these factors. It is shown that the inclusion of this constraint causes the OPF to preferentially select higher inertia generators as necessary, to satisfy the frequency security requirement. A genetic algorithm is utilized as the optimization tool in this work. The IEEE RTS-79 test system is used to demonstrate efficacy of the proposed method.
13 December 2021 in IEEE Transactions on Power Systems
Penetration of renewable energy resources (RERs) in the power grid continues to increase as we strive toward a greener environment for the future. While they have many advantages, most RERs possess little or no rotational kinetic energy, thereby threatening the frequency stability of future power grids. Energy storage systems (ESSs) can be used to mitigate this problem, as they are capable of providing virtual inertia to the system. This paper proposes a novel analytical approach for sizing ESSs to provide inertial support to the grid and maintain frequency stability in presence of RERs. This method analytically estimates the total inertia of the system using probability distributions of the outage states of conventional generators and RERs. RERs are modeled as multi-state units, considering the variability of their output power due to changes in weather conditions and also the forced outages of their equipment. The ESS is utilized to provide virtual inertia to the grid in the form of active power once the estimated system inertia falls below the minimum required during a disturbance. The efficacy of the proposed approach is tested on the IEEE 39 bus system and the results obtained by the analytical approach are validated using Monte Carlo simulation.
11 September 2020 in IET Generation, Transmission & Distribution
Energy storage systems (ESSs) are being deployed widely due to numerous benefits including operational flexibility, high ramping capability, and decreasing costs. This study investigates the economic benefits provided by battery ESSs when they are deployed for market‐related applications, considering the battery degradation cost. A comprehensive investment planning framework is presented, which estimates the maximum revenue that the ESS can generate over its lifetime and provides the necessary tools to investors for aiding the decision making process regarding an ESS project. The applications chosen for this study are energy arbitrage and frequency regulation. Lithium‐ion batteries are considered due to their wide popularity arising from high efficiency, high energy density, and declining costs. A new degradation cost model based on energy throughput and cycle count is developed for Lithium‐ion batteries participating in electricity markets. The lifetime revenue of ESS is calculated considering battery degradation and a cost–benefit analysis is performed to provide investors with an estimate of the net present value, return on investment and payback period. The effect of considering the degradation cost on the estimated revenue is also studied. The proposed approach is demonstrated on the IEEE Reliability Test System and historical data from PJM Interconnection.
19 April 2024 in IEEE Transactions on Power Systems
The integration of renewable energy resources (RERs) in the modern power grid is increasing rapidly because of aggressive decarbonization goals, lower costs, and increased government investment. However, higher penetrations of inverter-based generation can lead to frequency stability issues because of reduced system inertia. This paper develops a framework for quantifying the contribution of electric vehicles (EVs) toward providing frequency support to the grid and thus increasing the penetration limit of renewable energy resources (RERs). EVs are considered to provide both inertial response and primary frequency response support to the grid. A stochastic approach incorporating the uncertainties associated with the behavior of EVs is developed to derive the discharge limit of EV aggregators. A multi-machine system frequency response (MM-SFR) model is developed, which incorporates the dynamic virtual inertia and droop coefficients of EV aggregators derived from the EV control modules. Frequency security constraints are developed from this MM-SFR model, which, along with the converter voltage security and low voltage ride-through constraints, are integrated within a nonlinear optimization framework to determine the RER integration limit. The efficacy of the proposed approach is validated using the RTS-GMLC test system.