1 April 2024 in Applied Physics Letters
This report demonstrates Al0.93B0.7N thin films grown epitaxially on n-type GaN (0002)/c-plane sapphire substrates by reactive magnetron sputtering at 300 °C. At 200 nm film thickness, the Al0.93B0.07N layers exhibit partially relaxed substrate-induced epitaxial strain, a 0.16° wide (0002) rocking curve, in-plane crystallographic registry, and sub-nanometer surface roughness. Electrically, the stack shows robust hysteresis over three frequency decades, a remanent polarization of ∼125 μC/cm2, a strongly frequency dependent coercive field, highly uniform dc leakage currents, and endurance >106 field cycles. This report validates possibilities for ferroelectric nitride integration into conventional III-nitride heterostructures with high crystalline fidelity, high electrical resistivity, and persistent hysteresis. Such materials are synthesizable at thermal budgets and temperatures compatible with back-end-of-the-line boundary conditions.
1 December 2022 in APL Materials
CdO has drawn much recent interest as a high-room-temperature-mobility oxide semiconductor with exciting potential for mid-infrared photonics and plasmonics. Wide-range modulation of carrier density in CdO is of interest both for fundamental reasons (to explore transport mechanisms in single samples) and for applications (in tunable photonic devices). Here, we thus apply ion-gel-based electrolyte gating to ultrathin epitaxial CdO(001) films, using transport, x-ray diffraction, and atomic force microscopy to deduce a reversible electrostatic gate response from −4 to +2 V, followed by rapid film degradation at higher gate voltage. Further advancing the mechanistic understanding of electrolyte gating, these observations are explained in terms of low oxygen vacancy diffusivity and high acid etchability in CdO. Most importantly, the 6-V-wide reversible electrostatic gating window is shown to enable ten-fold modulation of the Hall electron density, a striking voltage-induced metal–insulator transition, and 15-fold variation of the electron mobility. Such modulations, which are limited only by unintentional doping levels in ultrathin films, are of exceptional interest for voltage-tunable devices.
2 July 2025 in Journal of Applied Physics
This work demonstrates ferroelectric switching in magnetron sputtered Al1−x−yBxScyN/n-GaN heterostructures. Using high power impulse magnetron sputtering, a silicon doped n-GaN bottom electrode with an electron concentration of 6.0 × 1019 cm−3 is grown on c-plane sapphire. Al1−x−yBxScyN films are prepared on the GaN surface with Al:B:Sc ratios that produce tensile, lattice matched, or compressive epitaxial strains. X-ray diffraction shows that lattice matched and compressively strained Al1−x−yBxScyN compositions are pseudomorphic, while partial relaxation is observed for tensilely strained Al1−x−yBxScyN/n-GaN heterostructures. Electrically, the Al1−x−yBxScyN/n-GaN stacks show robust hysteresis; the P–E loops are fully saturated with both lattice matched and compressively strained Al1−x−yBxScyN compositions exhibiting remanent polarization values of 135 μC/cm2. For comparison, Al1−x−yBxScyN films are also prepared on metal organic chemical vapor deposition and single crystal GaN substrates to extend strain and morphology trends to more common substrate types. This report validates that sputter deposition is a feasible technique for fabricating strain-tunable ferroelectric III–N heterostructures with high crystalline fidelity and smooth surface morphologies.