Department of Materials Science and Engineering, Materials Research Institute, Pennsylvania State University , University Park, Pennsylvania 16802, USA
Auto-generated profile, based on publicly available information
Fan He
Department of Materials Science and Engineering, Materials Research Institute, Pennsylvania State University , University Park, Pennsylvania 16802, USA
Wurtzite ferroelectrics are an emerging material class that expands the functionality and application space of wide bandgap semiconductors. Promising physical properties of binary wurtzite semiconductors include a large, reorientable spontaneous polarization, direct band gaps that span from the infrared to ultraviolet, large thermal conductivities and acoustic wave velocities, high mobility electron and hole channels, and low optical losses. The ability to reverse the polarization in ternary wurtzite semiconductors at room temperature enables memory and analog type functionality and quasi-phase matching in optical devices and boosts the ecosystem of wurtzite semiconductors, provided the appropriate combination of properties can be achieved for any given application. In this article, advances in the design, synthesis, and characterization of wurtzite ferroelectric materials and devices are discussed. Highlights include: the direct and quantitative observation of polarization reversal of ∼135 μC/cm2 charge in Al1−xBxN via electron microscopy, Al1−xBxN ferroelectric domain patterns poled down to 400 nm in width via scanning probe microscopy, and full polarization retention after over 1000 h of 200 °C baking and a 2× enhancement relative to ZnO in the nonlinear optical response of Zn1−xMgxO. The main tradeoffs, challenges, and opportunities in thin film deposition, heterostructure design and characterization, and device fabrication are overviewed.
This paper reports the retention behavior for Al0.93B0.07N thin films, a member of the novel family of wurtzite ferroelectrics. Our experiments suggest that bipolar cycling of metal (Pt/W)/Al0.93B0.07N/W/Al2O3 film stacks first induced wake-up and then a region of constant switchable polarization. The films showed excellent retention of the stored polarization state. As expected, data retention was slightly inferior in the opposite state (OS) measurements. However, it is noted that even after 3.6 × 106 s (1000 h) at 200 °C, the OS signal margin still exceeded 200 μC/cm2. The predicted OS retention is 82% after 10 yr baking at 200 °C.
This report demonstrates Al0.93B0.7N thin films grown epitaxially on n-type GaN (0002)/c-plane sapphire substrates by reactive magnetron sputtering at 300 °C. At 200 nm film thickness, the Al0.93B0.07N layers exhibit partially relaxed substrate-induced epitaxial strain, a 0.16° wide (0002) rocking curve, in-plane crystallographic registry, and sub-nanometer surface roughness. Electrically, the stack shows robust hysteresis over three frequency decades, a remanent polarization of ∼125 μC/cm2, a strongly frequency dependent coercive field, highly uniform dc leakage currents, and endurance >106 field cycles. This report validates possibilities for ferroelectric nitride integration into conventional III-nitride heterostructures with high crystalline fidelity, high electrical resistivity, and persistent hysteresis. Such materials are synthesizable at thermal budgets and temperatures compatible with back-end-of-the-line boundary conditions.
κ-Ga2O3 has been predicted to be a potential ferroelectric material. In this work, undoped Ga2O3 films were grown by either plasma-enhanced atomic layer deposition (PEALD) or metal organic chemical vapor deposition (MOCVD) on platinized sapphire substrates. 50 nm thick PEALD films with a mixture of κ-Ga2O3 and β-Ga2O3 had a relative permittivity of ∼27, a loss tangent below 2%, and high electrical resistivity up to ∼1.5 MV/cm. 700 nm thick MOCVD films with predominantly the κ-Ga2O3 phase had relative permittivities of ∼18 and a loss tangent of 1% at 10 kHz. Neither film showed compelling evidence for ferroelectricity measured at fields up to 1.5 MV/cm, even after hundreds of cycles. Piezoresponse force microscopy measurements on bare κ-Ga2O3 showed a finite piezoelectric response that could not be reoriented for electric fields up to 1.33 MV/cm.