A. K. M. Ashiquzzaman Shawon

A. K. M. Ashiquzzaman Shawon

Auto-generated profile, based on publicly available information

A. K. M. Ashiquzzaman Shawon

Department of Chemical Engineering and Materials Science Michigan State University East Lansing MI 48824 USA

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 February 2024 in Chemistry of Materials
Verified
Journal Article
Open access
ASA. K. M. Ashiquzzaman Shawon
A. K. M. Ashiquzzaman Shawon
WGWeeam Guetari
Weeam Guetari
KCKamil Ciesielski
Kamil Ciesielski
RORachel Orenstein
Rachel Orenstein
JQJiaxing Qu
Jiaxing Qu
AZAlexandra Zevalkink
Alexandra Zevalkink
AMX Zintl compounds, crystallizing in several closely related layered structures, have recently garnered attention due to their exciting thermoelectric properties. In this study, we show that orthorhombic CaAgSb can be alloyed with hexagonal CaAgBi to achieve a solid solution with a structural transformation at x ∼ 0.8. This transition can be seen as a switch from three-dimensional (3D) to two-dimensional (2D) covalent bonding in which the interlayer M-X bond distances expand while the in-plane M-X distances contract. Measurements of the elastic moduli reveal that CaAgSb1-xBix becomes softer with increasing Bi content, with the exception of a steplike 10% stiffening observed at the 3D-to-2D phase transition. Thermoelectric transport measurements reveal promising Hall mobility and a peak zT of 0.47 at 620 K for intrinsic CaAgSb, which is higher than those in previous reports for unmodified CaAgSb. However, alloying with Bi was found to increase the hole concentration beyond the optimal value, effectively lowering the zT. Interestingly, analysis of the thermal conductivity and electrical conductivity suggests that the Bi-rich alloys are low Lorenz-number (L) materials, with estimated values of L well below the nondegenerate limit of L = 1.5 × 10-8 W Ω K-2, in spite of the metallic-like transport properties. A low Lorenz number decouples lattice and electronic thermal conductivities, providing greater flexibility for enhancing thermoelectric properties.

6 June 2023 in Angewandte Chemie International Edition
Verified
Journal Article
Open access
SCSevan Chanakian
Sevan Chanakian
WPWanyue Peng
Wanyue Peng
VMVanessa Meschke
Vanessa Meschke
ASA. K. M. Ashiquzzaman Shawon
A. K. M. Ashiquzzaman Shawon
JAJesse Adamczyk
Jesse Adamczyk
AZAlexandra Zevalkink
Alexandra Zevalkink
AMX compounds with the ZrBeSi structure tolerate a vacancy concentration of up to 50 % on the M‐site in the planar MX‐layers. Here, we investigate the impact of vacancies on the thermal and electronic properties across the full EuCu1−xZn0.5xSb solid solution. The transition from a fully‐occupied honeycomb layer (EuCuSb) to one with a quarter of the atoms missing (EuZn0.5Sb) leads to non‐linear bond expansion in the honeycomb layer, increasing atomic displacement parameters on the M and Sb‐sites, and significant lattice softening. This, combined with a rapid increase in point defect scattering, causes the lattice thermal conductivity to decrease from 3 to 0.5 W mK−1 at 300 K. The effect of vacancies on the electronic properties is more nuanced; we see a small increase in effective mass, large increase in band gap, and decrease in carrier concentration. Ultimately, the maximum zT increases from 0.09 to 0.7 as we go from EuCuSb to EuZn0.5Sb.

18 April 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ASA. K. M. Ashiquzzaman Shawon
A. K. M. Ashiquzzaman Shawon
Soon-Chul UrSoon-Chul Ur
Soon-Chul Ur
Aluminum antimonide is a semiconductor of the Group III-V order. With a wide indirect band gap, AlSb is one of the least discovered of this family of semiconductors. Bulk synthesis of AlSb has been reported on numerous occasions, but obtaining a single phase has always proven to be extremely difficult. This work reports a simple method for the synthesis of single-phase AlSb. Subsequently, consolidation was done into a near single-phase highly dense semiconductor in a form usable for thermoelectric applications. Further, the thermoelectric properties of this system are accounted for the first time. In addition, the mechanical properties of the intermetallic compound are briefly discussed for a possibility of further use.

12 September 2023 in Materials Science and Engineering: A
Verified
Journal Article
Closed access
JBJ. Ballor
J. Ballor
ASA.A. Shawon
A.A. Shawon
AZA. Zevalkink
A. Zevalkink
TST. Sunaoshi
T. Sunaoshi
SMS. Misture
S. Misture
CBCarl Boehlert
Carl Boehlert

22 October 2019 in Journal of Electronic Materials
Verified
Journal Article
Closed access
PDF file
ASA. K. M. Ashiquzzaman Shawon
A. K. M. Ashiquzzaman Shawon
Soon-Chul UrSoon-Chul Ur
Soon-Chul Ur

12 January 2025 in Advanced Physics Research
Verified
Journal Article
Open access
RQRobert J. Quinn
Robert J. Quinn
YGYuji Go
Yuji Go
ANAaron B. Naden
Aaron B. Naden
ABAndras Bojtor
Andras Bojtor
GPGabor Paráda
Gabor Paráda
JBJan-Willem G Bos
Jan-Willem G Bos
Bandstructure engineering is a key route for thermoelectric performance enhancement. Here, 20–50% Seebeck (S) enhancement is reported for XNiCuySn half‐Heusler samples based on X = Ti. This novel electronic effect is attributed to the emergence of impurity bands of finite extent, due to the Cu dopants. Depending on the dispersion, extent, and offset with respect to the parent material, these bands are shown to enhance S to different degrees. Experimentally, this effect is controllable by the Ti content of the samples, with the addition of Zr/Hf gradually removing the enhancement. At the same time, the mobility remains largely intact, enabling power factors ≥3 mW m−1 K−2 near room temperature, increasing to ≥5 mW m−1 K−2 at high temperature. Combined with reduced thermal conductivity due to the Cu interstitials, this enables high average zT = 0.67–0.72 between 320 and 793 K for XNiCuySn compositions with ≥70% Ti. This work reveals the existence of a new route for electronic performance enhancement in n‐type XNiSn materials that are normally limited by their single carrier pocket. In principle, impurity bands can be applied to other materials and provide a new direction for further development.