Melt pool monitoring in selective laser melting (SLM) is a key challenge to enhance the understanding of the basic process physics as well as the in-situ identification of drifts. The main issues are related to the molten pool’s fast dynamics and small spatial extent, which require high performance monitoring systems in terms of temporal and spatial resolution, often resulting in unmanageable data rates. Furthermore, the broadband thermal emission from the process can be viewed in different spectral ranges depending on the sensor and optical system employed. Accordingly, a wide range of sensing configurations is possible. The choice of monitoring parameters is crucial to achieve a solution capable of describing process dynamics with industrial applicability in terms of data transport and analysis. This work discusses the design of a coaxial monitoring module to assess melt pool dynamics in SLM using temporal and spatial cues related to the process physics. Restrictions regarding data management were considered to ensure a future inline process control. The system was tested with an external illuminator to reveal the actual melt pool geometry employing an acquisition rate of 1200 fps, 4.3mm x 4.3mm field of view and 14 μm/pixel spatial resolution. The process emission in visible (640 nm) and near-infrared regions (850-1000 nm) was also acquired and the band choice discussed. The proposed solution captured successfully the melting conditions from both a spatial and temporal viewpoint. The monitoring system depicted the melt pool shape variations when processing different geometries using both modulated and continuous wave laser emission.
Coaxial imaging of melt pool dynamics provides several advantages over other monitoring methods in selective laser melting (SLM). The ability to track the processing zone ensures the possibility to observe defect formation dynamics mainly related to melting and solidification. Commonly, the melt pool dynamics are observed by means of process emission. In process emission images, geometrical information of the melt pool is not directly available and their extraction would require the use of a calibrated sensor in order to measure the temperature levels; as a consequence, commonly an arbitrary threshold is applied to the image. The use of external illumination for monitoring purposes allows for suppressing the process emission and observing the melt pool geometry by means of the reflected light. On the other hand, the obtained images show lower contrast and can be difficult to process by means of image processing algorithms. Accordingly, this work proposes the complementary use of external illumination to calibrate the melt pool geometry. Afterward, the process emission and melt pool dynamics in SLM are characterized. For the purpose, an open SLM platform with an in-house designed coaxial monitoring module is used. Images with external illumination were used to estimate the melt pool size for AISI 316L stainless steel. The information was used to set a threshold value for determining the melt pool size observed at the near-infrared emission band. The proposed strategy proved promising for real time monitoring and control applications and can represent a feasible solution for industrial systems.