Lukasz Pajewski

Lukasz Pajewski

Auto-generated profile, based on publicly available information

Lukasz Pajewski

Department of Telecommunications and Teleinformatics, Wrocław University of Science and Technology, ul. Wybrzeże Wyspiańskiego 27, 50-370 Wrocław, Poland

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 June 2019 in IEEE Sensors Journal
Verified
Journal Article
Closed access
MMMateusz Mądry
Mateusz Mądry
Lourdes AlwisLourdes Alwis
Lourdes Alwis
LBLeonardo Binetti
Leonardo Binetti
LPLukasz Pajewski
Lukasz Pajewski
EBElzbieta Beres-Pawlik
Elzbieta Beres-Pawlik
A fiber ring laser sensor setup utilizing FBGs (Fiber Bragg Gratings) for simultaneous measurement of ambient temperature and relative humidity (RH) is presented. Two FBGs are incorporated as tunable filters for a dual-wavelength laser emission, where one FBG was coated with Polyimide (PI) in order to achieve sensitivity to RH changes, while the other bare FBG was used for temperature sensing. An increase in RH would induce a strain on the grating, which results in a variation in the resonance wavelength of the PI-coated FBG. This causes a shift in the laser emission wavelength. Being insensitive to RH changes, the bare FBG was employed to measure temperature. The dual-wavelength fiber ring laser sensor created thus allows to determine simultaneous measurement of RH and temperature. The RH sensitivities observed by the PI coated FBG to RH and temperature are 3.6 pm/%RH and 12.15 pm/°C respectively. The temperature sensitivity of the bare FBG was observed to be 9.6 pm/°C. The main advantage of the proposed setup is an optical signal to noise ratio (OSNR) higher than 55 dB and a 3 dB-bandwidth less than 0.02 nm, which points out efficient capabilities for both precise sensing and remote detection applications.

18 August 2020 in Sensors
Verified
Journal Article
Open access
PDF file
ŁSŁukasz Sójka
Łukasz Sójka
LPLukasz Pajewski
Lukasz Pajewski
Samir LamriniSamir Lamrini
Samir Lamrini
MFMark Farries
Mark Farries
TBTrevor M. Benson
Trevor M. Benson
SSSlawomir Sujecki
Slawomir Sujecki
A diode-pumped Q-switched Er3+:ZBLAN double-clad, single-transverse mode fiber laser is practically realized. The Q-switched laser characteristics as a function of pump power, repetition rate, and fiber length are experimentally investigated. The results obtained show that the Q-switched operation with 46 µJ pulse energy, 56 ns long pulses, and 0.821 kW peak power is achieved at a pulse repetition rate of 10 kHz. To the best of our knowledge, this is the highest-ever demonstrated peak power emitted from an actively Q-switched, single-transverse mode Er3+:ZBLAN fiber laser operating near 2.8 µm.

11 September 2023 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
LPLukasz Pajewski
Lukasz Pajewski
ŁSŁukasz Sójka
Łukasz Sójka
Samir LamriniSamir Lamrini
Samir Lamrini
MFMark Farries
Mark Farries
Tomasz OsuchTomasz Osuch
Tomasz Osuch
SSSlawomir Sujecki
Slawomir Sujecki
A laboratory realization of an actively Q-switched Dy 3+ -doped fluoride fiber laser operating near 3.0 μm is reported. Two laser cavities were realized: one based on 1000 ppm Dy 3+ :ZBLAN fiber and one on 2000 ppm Dy 3+ :ZBLAN fiber. With the laser cavity based on 1000 ppm Dy 3+ :ZBLAN fiber a record high peak power of 200 W was achieved with 17 μJ pulse energy and 84.5 ns pulse duration. Moreover, a record short pulse duration of 74 ns was achieved using Q-switched laser cavity composed of 2000 ppm Dy 3+ :ZBLAN fiber.

12 November 2025 in Opto-Electronics Review
Verified
Journal Article
Open access
ŁSŁukasz Sójka
Łukasz Sójka
ŁPŁukasz Pajewski
Łukasz Pajewski
SSSlawomir Sujecki
Slawomir Sujecki
Samir LamriniSamir Lamrini
Samir Lamrini
MPMateusz Prorok
Mateusz Prorok
DDDominik Dorosz
Dominik Dorosz
A realisation of a Q-switched Tm3+-doped fibre laser operating at 1.96 μm wavelength is reported. The Tm3+-doped fibre was fabricated using a novel multi-ring modified chemical vapour deposition-chelate doping technique (MCVD-CDT) technology. The developed laser emits pulses at a repetition rate of 3 kHz with an energy of 84 μJ and a duration of 272 ns, which corresponds to a peak power of 304 W. The experimental results confirm that the fabricated Tm3+-doped multi-ring, large mode area fibre is a promising candidate for developing high-energy Q-switched lasers operating near 2 µm wavelength.

11 February 2017 in Optical and Quantum Electronics
Verified
Journal Article
Open access
PDF file
LPL. Pajewski
L. Pajewski
HSHanna Stawska
Hanna Stawska
EBE. Beres-Pawlik
E. Beres-Pawlik
The article presents the analysis of a double-clad microstructured optical fibre (DC MOF) couplers based on the ray tracing technique. The calculations were done for couplers made of well-defined fibre structures. Such couplers can be employed in laser systems using a DC MOF as a gain medium and a side pumping method which will allow to build fully-fiberized laser systems based on active microstructured fibres.

29 September 2025 in Opto-Electronics Review
Verified
Journal Article
Closed access
PDF file
MLMikołaj Lasota
Mikołaj Lasota
JBJordi Mongay Batalla
Jordi Mongay Batalla
SSSlawomir Sujecki
Slawomir Sujecki
AAAzadeh Ahmadian
Azadeh Ahmadian
ŁPŁukasz Pajewski
Łukasz Pajewski
PKPiotr Kolenderski
Piotr Kolenderski
This paper introduces quantum key distribution-as-a-service (QKDaaS) to address the end-to-end security challenges posed by the involvement of multiple orchestrators in 6G networks. These networks require seamless coordination of processes from endpoints to services, with tiered components supporting data-driven and cross-layer predictive procedures. While multi-party (spanning multiple domains, tenants, and providers) enhances local security through advanced controls, it also complicates the implementation of an end-to-end security framework that is essential for mobile network operators. To address this issue, we propose QKDaaS, a secure platform that leverages a fibre transport network for credential and encryption key distribution in multi-party environments. The solution uses wavelength multiplexing to integrate quantum and classical channels within a single fibre. Both C-band and O-band quantum channels are considered, with classical communication in the C-band. The simulation results show that with the currently available experimental setup and mobile network requirements, secure keys can be generated for distances approaching 100 km in the C-band and 60 km in the O-band case. This means that QKDaaS can be deployed in mobile network operators’ current transport infrastructures.