22 April 2008 in IEEE Journal of Solid-State Circuits
A self-testable and highly reliable low noise amplifier designed in 0.13 m CMOS technology is presented in this paper. This reliable LNA could be used to design the front-end of critical nodes in wireless local area networks to ensure data transmission. The LNA test, based on a built-in self test methodology, monitors its behavior. The test circuit is composed of one sensor and one biasing voltage sensor, and it offers high fault coverage. The high reliability is ensured by the use of redundancies. The LNA works under a 0.9 V supply voltage and the test chip has RF characteristics suitable for 802.11b/g applications. Parametric faults are injected and detected to demonstrate the efficiency of the BIST circuitry. Thanks to the switching on redundant blocks, performances are maintained and hence this proves the reliability of the methodology proposed.
22 April 2010 in IEEE Journal of Solid-State Circuits
Many technological bottlenecks prevent from realizing a software radio (SR) mobile terminal. The old way of building radio architectures is now over because a single handled terminal has to address various communication standards. This paper exposes a SR receiver: a sampled analog signal processor (SASP) is designed to perform downconversion and channel presorting. The idea is to process analog voltage samples in order to recover in baseband any RF signal emitted from 0 to 5 GHz. An analog fast Fourier transform achieves both frequency shifting and filtering. An experimental demonstrator of the SASP using 65 nm CMOS technology from STMicroelectronics is here presented and measured. It validates the concept of a new SR receiver with the design of a demonstrator which runs at 1.2 GHz consuming 389 mW.
1 July 2013 in Microelectronics Journal
15 April 2008 in IEEE Transactions on Circuits and Systems II: Express Briefs
The next generation of mobile terminals is faced with the emergence of the software-defined radio (SDR) concept. The communication devices tend to provide various wireless services through a multi-functional, multi-mode and multi-standard terminal. The SDR concept aims at designing a re-configurable radio architecture accepting all cellular or noncellular standards working in the 0-5-GHz frequency range. Some technical challenges have to be solved in order to address this concept. Working in the digital domain may be a solution but the analog-to-digital conversion cannot be done at Radio Frequencies, at an acceptable resolution and at an acceptable level of power consumption. The idea proposed here was to interface an analog pre-processing circuit between the antenna and a digital signal processor to pre-condition the RF signal. It uses the principle of a fast Fourier transform to carry out basic functions with high accuracy in a low-cost technology like CMOS. This paper presents the design and the behavioral simulations of this analog discrete-time device which gives the hardware flexibility required for a cognitive radio component.