2 December 2025 in Fusion Engineering and Design
27 March 2026 in IEEE Transactions on Applied Superconductivity
Solder-impregnated high-temperature superconducting (HTS) coils inherit challenges in predicting the coil characteristics due to their complex radial resistive pathways. Unlike insulated magnets, which require active quench protection and management schemes, non-insulated (NI) coils benefit from inherent quench tolerance through radial current bypass, but require advanced thermal-electrical models to predict charging time-constants and quench-tolerant performance under designed operating regimes. This research advances the electrical resistivity characterization of solder alloys at cryogenic temperatures, improving modelling predictions of coil properties. This paper will showcase the methodology utilized for characterizing low-temperature solder alloys, such as InBi, InSn, BiSnAg, and InAg, which enable solder-impregnation at lower reflow temperatures, therefore minimizing tape degradation. Experimental characterization data are validated against existing studies of SnPb solder. Solder characterization data are incorporated into finite element method (FEM) models to accurately describe temperature-dependent electrical resistivity characteristics between tape turns; thus, by ignoring the HTS layer to be insulating, together with temperature-dependent parameters, the radial resistance of coil 1A is evaluated from the model and compared against the experimental results. This work enhanced the understanding of solder-impregnated HTS coils, determining the design process of our future magnet systems.
12 January 2026 in IEEE Transactions on Applied Superconductivity
This paper presents an iterative method based on non-linear least squares for estimating the radial resistance of inductively coupled Non-insulated (NI) HTS coils. Although these results are of specific interest for levitated dipole fusion magnets, the estimation approach can be applied to any magnet composed of multiple NI HTS coils. OpenStar Technologies Ltd has developed a 5.6 T, 1.44 kA HTS magnet for a Levitated Dipole Reactor, named Junior, which consists of 14 individual NI coils. The proposed method was used to estimate the radial resistances in each of Junior’s 14 coils, from multiple sets of experimental data. The results showed good agreement between the estimated parameters and experimental data. The largest estimated radial resistance for one coil was 3.93 ${\mu }\mathrm{\Omega }$. The smaller outer coils had the lowest estimated radial resistance, spanning from 360–770 $\mathrm{n}\mathrm{\Omega }$. Estimates were consistent across all considered datasets for all coils, with the exception of coils 1 A and 2 B.