1 March 2021 in Journal of Construction Engineering and Management
Workers in industrialized construction are often exposed to physical demands (e.g., repetitive motion and awkward body posture) associated with the risks of work-related musculoskeletal disorders, despite the utilization of automated equipment. To reduce exposure to these risks, an investigation of workstation design is needed. This paper proposes a virtual reality (VR)-based ergonomic assessment method that identifies ergonomic risk ratings proactively in the initial phases of workstation design, thus reducing the need for physical mock-ups and lessening the cost and time required to develop and implement an improved workstation design. This method was demonstrated in an operational task through an experiment conducted with 13 participants. Compared with the physical mock-up, the designed VR application achieved an accuracy of approximately 86% and 80%, respectively, in Rapid Upper Limb Assessment and Rapid Entire Body Assessment to assess risk. Moreover, a questionnaire was developed to obtain feedback from participants on their perceptions toward the designed VR application, which further supported the success of using the proposed VR-based ergonomic assessment method.
1 August 2022 in Journal of Construction Engineering and Management
Workers in offsite construction facilities are often exposed to repetitive motion and awkward body postures that are associated with the risk of developing work-related musculoskeletal disorders despite the use of automated equipment on production lines. To reduce the exposure to these risks, an investigation of the physical demands that workstations impose on workers’ bodies is needed. Since traditional methods used to collect human body motions have limitations, such as workplace interruptions and biased results due to subjective observation, this paper proposes a virtual reality (VR)–motion capture (MOCAP)-based ergonomic assessment method to evaluate ergonomic risks in a laboratory setting during the design phase of workstation development. It is expected that the number of iterations of physical workstation prototypes would be reduced if ergonomic risk ratings are identified proactively in the initial phases of workstation design, which would thereby reduce the cost and time required to develop and implement an improved workstation design. The present study includes a feasibility analysis of the proposed method in which participants representative of specific percentiles of the population based on their physical stature were invited to voluntarily participate in a research experiment. The results obtained demonstrate that the proposed method can successfully simulate the elemental motions, referred to as therbligs, of reaching and positioning (Pearson’s correlation coefficient is found to equal 0.80 and 0.94, respectively), while the simulation of the assembling therblig requires further investigation. The contribution of this study is a virtual reality–motion captured-enabled ergonomic risk assessment method applied to workstation design for offsite construction production lines. In addition, the deployment of the proposed method allows a holistic ergonomic assessment that considers objective and subjective parameters.
1 October 2023 in Journal of Construction Engineering and Management
25 June 2021 in International Journal of Simulation and Process Modelling
Workers in the construction manufacturing industry are exposed to labour-intensive tasks with ergonomic risks such as forceful exertion and repetitive motion. Due to increased productivity and repetitive motions resulting from improvement initiatives implemented in offsite construction manufacturing, the investigation of ergonomic risks associated with these changes is needed. In this context, this paper explores an existing panelised floor production line aiming to minimise its ergonomic risks while improving its current productivity rate. Information pertaining to human body motion and productivity is extracted from video recordings. The ergonomic risks associated with specific tasks are identified using two existing ergonomic risk assessment methods: the rapid entire body assessment and the rapid upper limb assessment. A simulation model is used to evaluate various process improvements from the perspective of both ergonomic risks and productivity to support the decision-making process and the prioritisation of process changes in the factory.