Low-temperature synthesis methods are used to produce nanoceramic materials for electrodes of the following ionistors: (ZrO2)0.6(In2O3)0.4, praseodymium cobaltite, as well as neodymium, lanthanum, and nickel chromites; they operate in the presence of an ion-conducting phosphorosilicate separator membrane and phosphate impregnation. Film electrodes of ionistors are fabricated that consist of nanocrystalline oxide materials deposited as a thin film on a porous electroconductive metal substrate, i.e., foamed nickel. The MnO2-foamed nickel electrode has a specific capacity of 45.0 F g−1, which is compared with that of industrial supercapacitors.
Investigations for developing ultimate rating microturbogenerators based on modern materials were executed. Maximum permissible electromechanical and mechanical loads depending on minimum permissible core dimensions for microturbogenerators with rating of 100 and 200 kW and speed of rotation 30000-100000 rpm are determined. Complex simulation models for the purpose of chosen generator parameters optimization and for 3D contact problems decision based on numerical finite element method are worked out. For principal decision of mechanical problems for microturogenerator with rating of 200 kW and speed of rotation 100000 rpm and more, it's necessary to use new materials of higher strength. Consequently the most essential physical characteristics of strip cylinder materials which exert influence on the geometric dimension changes limits were find out to raise microturogenerator capacity.
The state of the surface of organic-inorganic coatings derived by sol-gel technology on a steel surface and their effect on the reduction of the air friction losses of a mini-turbogenerator rotor were studied. Two hypotheses about the effect of the surface condition on the reduction of the air friction losses—by improving the surface smoothness and by creating a superhydrophobic surface—were suggested and tested. Smooth epoxy-titanate coatings including those doped with a fluorine-containing organosilicon polymer and superhydrophobic surfaces based on hydrolyzed methyltriethoxysilane with an aerosol additive were tested on a model mini-turbogenerator test setup. It was established that the smooth coatings reduce the total friction losses of the mini-turbogenertor by ∼5%, while the superhydrophobic coatings reduce them by ∼7%.
The current state of high-speed electrical machines with shaft rotation velocity within the range of 10 000 to 50 000 rpm is considered and the development trends are analyzed. The analysis includes recent publications and the results of the authors’ studies. Data of the developed motors and generators are presented. Forecasts regarding directions in the development of high-speed electrical machines are made.
Three compositions based on epoxide-siloxane, epoxide-titanate, modified epoxide-titanate sols have been synthesized by the sol-gel method, and the morphology of surface and the hydrophobicity of coatings obtained on their basis has been studied. According to the results of the studies, the compositions of the coatings have been chosen for the conduction of tests on a rotor of high-rpm miniturbogenerator, with the aim to determine the effect of aerodynamic losses.
The modern design tendencies of wind power generators based on synchronous machines with permanent magnets have been analyzed. It is shown that it is possible to create a spectrum of wind power generators with tangential magnetic flux and stator concentric windings in the range of rotation frequencies of 75–300 rpm. Some parameters of the developed generators are presented.