This study explores the possibility of transforming lignocellulose-rich agricultural waste materials into value-added products. Cellulose was extracted from an empty fruit bunch of oil palm and further modified into carboxymethyl cellulose (CMC), a water-soluble cellulose derivative. The CMC was then employed as the polymeric content in fabrication of solid polymer electrolyte (SPE) films incorporated with lithium iodide. To enhance the ionic conductivity of the solid polymer electrolytes, the compositions were optimized with different amounts of glycerol as a plasticizing agent. The chemical and physical effects of plasticizer content on the film composition were studied by Fourier transform infrared (FTIR) and X-ray diffraction (XRD) analysis. FTIR and XRD analysis confirmed the interaction plasticizer with the polymer matrix and the amorphous nature of fabricated SPEs. The highest ionic conductivity of 6.26 × 10−2 S/cm was obtained with the addition of 25 wt % of glycerol. By fabricating solid polymer electrolytes from oil palm waste-derived cellulose, the sustainability of the materials can be retained while reducing the dependence on fossil fuel-derived materials in electrochemical devices.
18 March 2022 in Journal of Solar Energy Engineering
The use of naturally extracted compounds as dye sensitizers is a very promising alternative for the manufacture of low-cost solar cells. These directly convert solar energy to electricity. In the present study, Aloe Latex Solid (ALS), which is an orange-yellow solid compound extracted from Aloe Vera leaves, was deposited on a TiO2 thin film (TiO2/ALS) for the construction of two different solar cell configurations. The UHPLC-DAD-ESI-MS analysis, UV–Vis and FTIR spectroscopic studies were performed for the prepared dye sensitizer. In fact, the performance of the TiO2/ALS composite was investigated in a heterojunction dye sensitized solar cell (HJ-DSSC) and a liquid electrolyte-based dye sensitized solar cell (LE-DSSC) to identify the architecture with highest efficiency of sunlight conversion. The solar cells photovoltaic performance in terms of short-circuit current, open circuit voltage, fill factor and energy conversion efficiency was tested with photocurrent density–voltage measurements. Interesting solar conversion efficiencies were obtained for both architectures with a maximum value of about 1.17% corresponding to the LE-DSSC configuration.