Martin Frentrup

Martin Frentrup

Auto-generated profile, based on publicly available information

Martin Frentrup

Department of Materials Science and Metallurgy, University of Cambridge, Cambridge CB3 0FS, United Kingdom

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 September 2017 in Journal of Physics D: Applied Physics
Verified
Journal Article
Open access
PDF file
MFMartin Frentrup
Martin Frentrup
LLLok Yi Lee
Lok Yi Lee
SSSuman-Lata Sahonta
Suman-Lata Sahonta
MKMenno J Kappers
Menno J Kappers
FMFabien Massabuau
Fabien Massabuau
DWDavid J Wallis
David J Wallis
Solving the green gap problem is a key challenge for the development of future LED-based light systems. A promising approach to achieve higher LED efficiencies in the green spectral region is the growth of III-nitrides in the cubic zincblende phase. However, the metastability of zincblende GaN along with the crystal growth process often lead to a phase mixture with the wurtzite phase, high mosaicity, high densities of extended defects and point defects, and strain, which can all impair the performance of light emitting devices. X-ray diffraction (XRD) is the main characterization technique to analyze these device-relevant structural properties, as it is very cheap in comparison to other techniques and enables fast feedback times. In this review, we will describe and apply various XRD techniques to identify the phase purity in predominantly zincblende GaN thin films, to analyze their mosaicity, strain state, and wafer curvature. The different techniques will be illustrated on samples grown by metalorganic vapor phase epitaxy on pieces of 4″ SiC/Si wafers. We will discuss possible issues, which may arise during experimentation, and provide a critical view on the common theories.

20 December 2020 in Micromachines
Verified
Journal Article
Open access
PDF file
ABArmin Barthel
Armin Barthel
JRJoseph Roberts
Joseph Roberts
MNMari Napari
Mari Napari
MFMartin Frentrup
Martin Frentrup
THTahmida Huq
Tahmida Huq
FMFabien C-P Massabuau
Fabien C-P Massabuau
The suitability of Ti as a band gap modifier for α-Ga2O3 was investigated, taking advantage of the isostructural α phases and high band gap difference between Ti2O3 and Ga2O3. Films of (Ti,Ga)2O3 were synthesized by atomic layer deposition on sapphire substrates, and characterized to determine how crystallinity and band gap vary with composition for this alloy. We report the deposition of high quality α-(TixGa1−x)2O3 films with x = 3.7%. For greater compositions the crystalline quality of the films degrades rapidly, where the corundum phase is maintained in films up to x = 5.3%, and films containing greater Ti fractions being amorphous. Over the range of achieved corundum phase films, that is 0% ≤ x ≤ 5.3%, the band gap energy varies by ∼270 meV. The ability to maintain a crystalline phase at low fractions of Ti, accompanied by a modification in band gap, shows promising prospects for band gap engineering and the development of wavelength specific solar-blind photodetectors based on α-Ga2O3.

20 July 2020 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
SCS. A. Church
S. A. Church
BDB. Ding
B. Ding
PMP. W. Mitchell
P. W. Mitchell
MKM. J. Kappers
M. J. Kappers
MFM. Frentrup
M. Frentrup
DBD. J. Binks
D. J. Binks
Zincblende InGaN/GaN quantum wells offer a potential improvement to the efficiency of green light emission by removing the strong electric fields present in similar structures. However, a high density of stacking faults may have an impact on the recombination in these systems. In this work, scanning transmission electron microscopy and energy-dispersive x-ray measurements demonstrate that one-dimensional nanostructures form due to indium segregation adjacent to stacking faults. In photoluminescence experiments, these structures emit visible light, which is optically polarized up to 86% at 10 K and up to 75% at room temperature. The emission redshifts and broadens as the well width increases from 2 nm to 8 nm. Photoluminescence excitation measurements indicate that carriers are captured by these structures from the rest of the quantum wells and recombine to emit light polarized along the length of these nanostructures.

22 July 2024 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
SGSaptarsi Ghosh
Saptarsi Ghosh
MSM. Sarkar
M. Sarkar
MFM. Frentrup
M. Frentrup
MKM. J. Kappers
M. J. Kappers
RORachel Oliver
Rachel Oliver
Distributed Bragg reflectors (DBRs) based on alternating layers of porous and non-porous GaN have previously been fabricated at the wafer-scale in heteroepitaxial GaN layers grown on sapphire substrates. Porosification is achieved via the electrochemical etching of highly Si-doped layers, and the etchant accesses the n+-GaN layers through nanoscale channels arising at threading dislocations that are ubiquitous in the heteroepitaxial growth process. Here, we show that the same process applies to GaN multilayer structures grown on silicon substrates. The reflectance of the resulting DBRs depends on the voltage at which the porosification process is carried out. Etching at higher voltages yields higher porosities. However, while an increase in porosity is theoretically expected to lead to peak reflectance, in practice, the highest reflectance is achieved at a moderate etching voltage because etching at higher voltages leads to pore formation in the nominally non-porous layers, pore coarsening in the porous layers, and in the worst cases layer collapse. We also find that at the high threading dislocation densities present in these samples, not all dislocations participate in the etching process at low and moderate etching voltages. However, the number of dislocations involved in the process increases with etching voltage.

10 October 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
YJYihong Ji
Yihong Ji
MFMartin Frentrup
Martin Frentrup
XZXiaotian Zhang
Xiaotian Zhang
JPJakub Pongrácz
Jakub Pongrácz
SFSimon M. Fairclough
Simon M. Fairclough
RORachel Oliver
Rachel Oliver
Strain-related piezoelectric polarization is detrimental to the radiative recombination efficiency for InGaN-based long wavelength micro-LEDs. In this paper, partial strain relaxation of InGaN multiple quantum wells (MQWs) on the wafer scale has been demonstrated by adopting a partially relaxed InGaN superlattice (SL) as the pseudo-substrate. Such a pseudo-substrate was obtained through an electro-chemical etching method, in which a sub-surface InGaN/InGaN superlattice was etched via threading dislocations acting as etching channels. The degree of strain relaxation in MQWs was studied by x-ray reciprocal space mapping, which shows an increase of the in-plane lattice constant with the increase of etching voltage used in fabricating the pseudo-substrate. The reduced strain in the InGaN SL pseudo-substrate was demonstrated to be transferable to InGaN MQWs grown on top of it, and the engineering of the degree of strain relaxation via porosification was achieved. The highest relaxation degree of 44.7% was achieved in the sample with the porous InGaN SL template etched under the highest etching voltage. Morphological and structural properties of partially relaxed InGaN MQWs samples were investigated with the combination of atomic force and transmission electron microscopy. The increased porosity of the InGaN SL template and the newly formed small V-pits during QW growth are suggested as possible origins for the increased strain relaxation of InGaN MQWs.

9 March 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
HXHuixin Xiu
Huixin Xiu
SFSimon M. Fairclough
Simon M. Fairclough
AGAbhiram Gundimeda
Abhiram Gundimeda
MKMenno J. Kappers
Menno J. Kappers
DWDavid J. Wallis
David J. Wallis
MFMartin Frentrup
Martin Frentrup
Aberration-corrected scanning transmission electron microscopy techniques are used to study the bonding configuration between gallium cations and nitrogen anions at defects in metalorganic vapor-phase epitaxy-grown cubic zincblende GaN on vicinal (001) 3C-SiC/Si. By combining high-angle annular dark-field and annular bright-field imaging, the orientation and bond polarity of planar defects, such as stacking faults and wurtzite inclusions, were identified. It is found that the substrate miscut direction toward one of the 3C-SiC ⟨110⟩ in-plane directions is correlated with the crystallographic [1–10] in-plane direction and that the {111} planes with a zone axis parallel to the miscut have a Ga-polar character, whereas the {111} planes in the zone perpendicular to the miscut direction have N-polarity. The polarity of {111}-type stacking faults is maintained in the former case by rotating the coordination of Ga atoms by 180° around the ⟨111⟩ polar axes and in the latter case by a similar rotation of the coordination of the N atoms. The presence of small amounts of the hexagonal wurtzite phase on Ga-polar {111} planes and their total absence on N-polar {111} planes is tentatively explained by the preferential growth of wurtzite GaN in the [0001] Ga-polar direction under non-optimized growth conditions.