6 May 2020 in IET Microwaves, Antennas & Propagation
A wide‐band push–push common‐collector Colpitts voltage‐controlled oscillator (VCO) usingimpedance peaking network and gain enhancing technique is proposed in this work.The impedance peaking network is introduced to increase the coupling factor ofthe differential inductor in the inductorcapacitor (LC) tank without sacrificing the quality factor. The impedancepeaking technique could guarantee the push–push VCO unconditionally oscillatingin a differential mode without degrading the phase noise performance. The gainenhancing technique employs an LC resonator in series with the emitterdegeneration resistor in the common‐collector amplifier in the VCO core toimprove the VCO oscillating amplitude and then improve the phase noiseperformance. The proposed VCO oscillates at around 20 GHz with >10.5%frequency tuning range from 18.9 to 21.4 GHz across temperature from −40 to125°C. The measured phase noise is lower than −107 dBc/Hz at 1 MHz offset acrossthe entire working temperature (−40 125°C). The whole VCO dissipates 45 mA under3.3 V power supply, and the typical figure of merit is around −177.92.
1 July 2021 in Journal of Physics: Conference Series
Under the background that electronic products have been developing in the direction of being smaller, lighter and cheaper, the packaging of chip components has also been continuously improved. Fan-out panel-level package (FOPLP) is one of the latest development trends in microelectronics package, which can achieve higher productivity and lower costs. A planar toroidal spiral transformer is designed based on Fan-Out Panel Level Package technology. The transformer is constructed by two RDL layers provided by the packaging process. The size of the proposed transformer is 434um×434um. The simulated primary and secondary inductance is 2.5nH and 2.5nH respectively. The coupling factor of the transformer is 0.845. The quality factor of the transformer is higher than 800 during the entire working frequency range. The self-resonant frequency of the present transformer is 20 GHz. Compared to the on-chip counterpart, the transformer designed based on Fan-Out Panel Level Package technology can achieve higher coupling factor and quality factor. Therefore, the proposed transformer can save chip size and reduce the cost through avoiding using area hungry passive on chip transformer.
1 January 2025 in The Journal of Engineering
An ultra‐wideband voltage‐controlled oscillator (VCO) based on the Colpitts structure is proposed in this work. The entire circuit consists of four Colpitts VCO cores operating at different frequencies. Every VCO core employs two single‐ended Colpitts oscillators arranged back‐to‐back and sharing a common LC resonating tank. The coupling coefficient between the two single‐ended Colpitts oscillators is increased by introducing a transformer placed on the emitter node of the core transistor, which ensures two Colpitts oscillators oscillating in differential mode. Furthermore, a series of analogue signal processing circuits, including a fundamental signal amplifier, second harmonic signal amplifier, and frequency doubler, are employed to amplify the second and fourth harmonic signals, thereby greatly expanding the operating frequency bandwidth of the proposed VCO. The oscillating frequency of the proposed Colpitts VCO ranges from 3.5 to 7 GHz, and the maximum frequency can reach up to 14 GHz or 28 GHz through generating the second or fourth harmonics. The measured phase noise performance at 1 MHz offset is lower than ‐130dBc/Hz, −124 dBc/Hz and −118 dBc/Hz at 3.5 GHz∼7 GHz, 7GHz∼14 GHz, 14 GHz∼28 GHz frequency bands, respectively. The power dissipation of the entire VCO is typically around 60 mW under a 3.3 V power supply.