Quan-Wei Lin

Quan-Wei Lin

Auto-generated profile, based on publicly available information

Quan-Wei Lin

Department of Electrical Engineering, State Key Laboratory of Terahertz Millimeter Waves, City University of Hong Kong, Kowloon Tong, Hong Kong

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 March 2019 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
MHMo Huang
Mo Huang
YLYue Long Lin
Yue Long Lin
JOJun-Hui Ou
Jun-Hui Ou
XZXiu Yin Zhang
Xiu Yin Zhang
QLQuan Wei Lin
Quan Wei Lin
QXQuan Xue
Quan Xue
This paper presents an automatic impedance transforming technique to extend the radio frequency rectifier input power range with high conversion efficiency. The rectifier employs two branches of subrectifier, each achieving impedance matching at high and low input power ranges. Then, the two branches are connected by a λ/4 T-junction power divider. With such configuration, the input impedance of the two subrectifiers are transformed automatically, allowing the impedance matching over a wide input power range. In this way, the injected power can be optimally delivered to the subrectifiers, achieving a high efficiency over this wide input power range. This scheme manages to eliminate the power detetor for branch selection and can be applied to both singleand dual-band rectifiers with a reduced design difficulty. For validation, a single-band rectifier working at 915 MHz and a dual-band rectifier at 915/2450 MHz are implemented. Design analysis on the singleand dual-band rectifiers is carried out. The measurement results show that 68% maximum efficiency is achieved for the single-band (915 MHz) rectifier, and the input power range for the efficiency 70% of the peak efficiency is from -5 to 31 dBm. Besides, the dual-band rectifier shows 66% and 58% peak efficiencies at 915 and 2450 MHz, respectively. The input power range is from -6 to 33 dBm for the efficiency 70% of its peak value at 915 MHz, while from 10 to 32 dBm at 2450 MHz. These indicate that the input power range with high efficiency is extended.


21 August 2018 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
QLQuan-Wei Lin
Quan-Wei Lin
HWHang Wong
Hang Wong
This paper presents a low-profile and wideband metamaterial-lens (metalens) antenna based on high-refractive-index metasurface. A novel three-layer nonresonant metamaterial unit cell is introduced and analyzed by the full-wave simulation tool. The proposed unit cell is a stacking configuration of four H-shaped lines realized by multiple microwave laminates. It can achieve a large refractive index variation range of 4.76 (from 1.5 to 6.26). In addition, two impedance matching layers based on the proposed unit cell are developed to provide better transmission for incident waves passing through the metalens antenna. The attractiveness of this new metalens antenna is its low-profile thickness of $0.26~\lambda _{0}$ , where $\lambda _{0}$ is the wavelength at 10 GHz. To validate the performance of the metalens antenna, a wideband stub-loaded horn antenna with stable radiation patterns in E- and H-planes is adopted as the feeding antenna source. The measured results demonstrate a wide impedance bandwidth of 66% (7.2–14.3 GHz) and a high aperture efficiency of up to 65%. Moreover, its sidelobe and cross-polarization levels are less than −17 and −25 dB across the entire bandwidth, respectively.

28 July 2020 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
QGQing-Yi Guo
Qing-Yi Guo
QLQuan Wei Lin
Quan Wei Lin
HWHang Wong
Hang Wong
This communication introduces a new structure of polarizer for generating millimeter-wave (MMW) circular polarization (CP) in a Fabry-Perot Cavity (FPC) antenna. It is the first of its kind which integrates a 3D-printed polarizer with an inserted partially reflective surface (PRS), which contributes to a wideband CP operation with high antenna gain. The realization of CP and gain enhancement can be controlled independently by optimizing the structures of the dielectric part and the PRS of the polarizer, respectively. The proposed antenna consists of a feeding source, a substrate-integrated quasi-curve reflector and the proposed polarizer. The feeding source and the reflector are able to be fabricated by the conventional PCB technology which is low-cost and convenient in circuitry integration. For validation, a prototype of the FPC antenna with the proposed polarizer operating at 60 GHz has been designed, fabricated and measured. The peak gain of the antenna reaches to 20 dBic. The antenna achieves an impedance bandwidth of 20% from 54.5 to 66.7 GHz for the reflection coefficient less than -10 dB. The axial ratio (AR) bandwidth is 12.7% from 56.5 to 64 GHz for AR ≤ 3 dB. Experimental results confirm a good agreement between simulation and measurement.

2 December 2022 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
QLQuan-Wei Lin
Quan-Wei Lin
SAShaker Alkaraki
Shaker Alkaraki
HWHang Wong
Hang Wong
JKJames R. Kelly
James R. Kelly
This paper presents a novel circularly- polarized (CP) antenna based on an anisotropic metamaterial. The antenna is capable of performing linear-to-circular polarization conversion over a wideband of frequencies in the X-band (8-12GHz). The proposed antenna was constructed from a metamaterial-based polarizer mounted above the aperture of a rectangular waveguide. The polarizer was oriented at 45 degrees to E-plane of the waveguide. The proposed polarizer is composed of multiple metamaterial layers. The unit cell of the proposed polarizer consists of a single dielectric slab incorporating a series of rectangular split ring resonators that are printed on both sides of the slab. Impedance matching layers (IML) are introduced to enhance the Axial-ratio (AR) bandwidth. The polarizer has a low profile in terms of electrical length (thickness of 0.41 λ 0 , where λ 0 is the free-space wavelength at 10.5 GHz). A full-wave electromagnetic simulator was used to verify the anisotropic characteristics of the unit cell. This was achieved by showing that the metamaterial exhibits two different refractive indices along the orthogonal components of the incident electric field. The prototype of the proposed design is fabricated and measured to validate the performance. The measured results agree with the simulated ones and demonstrated a wide impedance bandwidth of 62.4% ranging from 7.08 GHz to 13.5 GHz with a 3dB AR bandwidth of 29.9% (9.25-12.5 GHz).

8 September 2023 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SAShaker Alkaraki
Shaker Alkaraki
QLQuan Wei Lin
Quan Wei Lin
Alejandro L. BorjaAlejandro L. Borja
Alejandro L. Borja
Zhengpeng WangZhengpeng Wang
Zhengpeng Wang
HWHang Wong
Hang Wong
JKJames R. Kelly
James R. Kelly
This article presents a proof of concept demonstrator for a pair of novel phase shifters based on substrate integrated waveguide (SIW) technology. Gallium-based liquid metal (LM) is used to reconfigure each phase shifter. This article presents LM phase shifters that, for the first time, have a phase shifting range of 360 $^{\circ}$ . The phase shifters have a small electrical size, and they are intended for use within phased array antenna applications. This article also presents a design procedure for the phase shifters. The procedure has been used to design two phase shifters operating at 10 GHz. The design process can be readily scaled for operation at other frequencies. The proposed phase shifters are reciprocal and bidirectional, and they have very low insertion loss (IL). A series of reconfigurable LM vias are used to achieve the phase shift. Each of LM via is activated once a drill hole is filled with LM and it is deactivated once LM is removed. Using this method, it is possible to achieve a phase shift step ranging from 1 $^{\circ}$ to 100 $^{\circ}$ using a single LM via. Moreover, the overall phase shift can be extended to 360 $^{\circ}$ by employing several LM vias in series inside the SIW. The proposed phase shifters have an IL lower than 3 dB and provide a total phase shifting range of approximately 360 $^{\circ}$ in eight steps of approximately 45 $^{\circ}$ each. This enables the proposed two phase shifters to have an extraordinary figure of merit (FoM) of 131.3 $^{\circ}$ /dB and 122.4 $^{\circ}$ /dB.