15 December 2017 in IEEE Electron Device Letters
An AlGaN/GaN double-channel Schottky barrier diode (DC-SBD) with dual-recess gated anode is demonstrated in this letter. The DC-SBD features two recess steps. The deep one cuts through two channels and the anode metal contacts 2DEG directly from the sidewall of the recessed heterostructure. The shallow one terminates at the upper channel layer and is located adjacent to the Schottky contact. A MOS field plate is placed on the shallow recess region to pinch off the underlying channels, so the off-state leakage current of the DC-SBD can be suppressed. Since the lower channel is separated from the etched surface, the field effect mobility beneath this MOS structure shows a high peak value of 1707 cm2/(V·s). The DC-SBD with an anode-to-cathode length (Lac) of 15 µm exhibits a turn-on voltage (VT) of ~0.6 V (at 1 mA/mm), a leakage current of 7.8 nA/mm (at .100 V), and a breakdown voltage of 704 V (at 1 µA/mm). The double-channel design also allows both the deep and shallow recess to be terminated at GaN layers that results in high uniformity of VT.
3 July 2018 in IEEE Electron Device Letters
The OFF-state drain leakage characteristics in 600-V p-GaN HEMTs with an ohmic gate contact are investigated under dynamic switching conditions instead of commonly used quasi-static measurement setup. It is found that fast dynamic OFF-state leakage current (dynamic I OFF ) is substantially higher than the slow-ramping quasi-static I OFF due to the weaker trapping effect in the buffer layer. With sufficiently large positive ON-state gate bias, further increase in dynamic I OFF is observed and is attributed to ON-state hole injection that leads to energy band lowering in the buffer. The underlying physical processes are explained by the dynamic behavior of the traps in the buffer layer. This letter indicates that the I OFF under practical switching operations is much higher than the static measurement results and should be used to evaluate dynamic OFF-state power consumption in the p-GaN HEMTs with an ohmic gate contact.
1 May 2018 in IEEE Electron Device Letters
An MOS field plate-protected Schottky-drain (gated Schottky-drain) is successfully integrated on a double-channel AlGaN/GaN MOS-HEMT to provide reverse blocking capability. The leakage suppression MOS field plate is deployed on the etched upper GaN channel layer after a barrier fully recess process, leading to a low reverse OFF-state leakage current of -20 nA/mm (at -100 V). The drain metal is deployed adjacent to the MOS field plate, contacting the upper MOS-channel and lower heterojunction channel from the sidewall. A metal-2DEG Schottky contact with a low turn-ON voltage of 0.5 V is achieved. Since the lower channel (below the MOS field plate) is separated from the etched surface of upper GaN channel layer, a high-conductivity MOS-gated channel with a sheet resistance of 806 Q/Square is obtained. The device exhibits a threshold voltage of +0.6 V (at 10 μA/mm and +1.9 V from linear extrapolation) and an ON-resistance of ~18 Ω·mm. Besides, a high forward (and reverse) breakdown voltage of 790 V (and -656 V, all at 10 μA/mm) is achieved.
18 December 2019 in IEEE Transactions on Industrial Electronics
Systematic characterizations of a cascode device with a low-voltage (LV) enhance-mode (E-mode) p-GaN gate HEMT as the control device and a high-voltage (HV) depletion-mode (D-mode) SiC JFET as the voltage blocking device are presented. The demonstrated device with a breakdown voltage (BV) rating of 1200 V and a static ON-resistance ( $R_{ON}$ ) of 100 mΩ, features small device capacitances with fast switching speed, avalanche breakdown capability, thermally stable threshold voltage ( $V_{TH}$ ), and no dynamic $R_{ON}$ degradation. To identify its safe operation in the OFF-state with a high drain bias, the OFF-state middle point voltage (V $M$ ) between the E-mode device drain and D-mode device source is investigated. A relatively low OFF-state $V_M$ is achieved under both static and dynamic modes. In addition to the device-level characterization, a custom-designed double-pulse test circuit is built to evaluate the transient switching performance of the cascode device. Optimal gate drive conditions are proposed to 1) overcome the drain bias induced positive dynamic $$V_{TH}$ shift; and 2) suppress the increased dynamic OFF-state leakage current ( $I_{OFF}$ ) induced by ON-state hole injection. Under 800-V/16-A testing conditions, high switching speed with the drain voltage peak slew rates of 72 V/ns during turn-on and 121 V/ns during turn-off is achieved.
21 July 2020 in IEEE Electron Device Letters
When the gated channel region of a GaN highelectron-mobility transistor (HEMT) is configured into multiple sub-channels in parallel and separated by embedded isolating patterns, the effective resistance of the access regions could be reduced, and consequently, the knee voltage (VK) of the transistor could be lowered. In this work, each sub-channel is defined as a convergent funnellike shape, with its width gradually shrunk from the source side to the drain side. Different from conventional channels with uniform width under the entire gate, the funnel-shaped channel could converge electrons as they transport from source side to drain side, which facilitates electrons’ acceleration toward saturation velocity under a smaller drain-to-source bias, leading to a reduced intrinsic VK in the gated channel. Thus, more desirable I-V characteristics and more balanced performance enhancement in RF linearity and power added efficiency are achieved at a low supply voltage, making the convergent-channel HEMT attractive for power amplifiers in mobile terminals.
9 November 2017 in IEEE Electron Device Letters
A previously reported normally-off GaN double-channel (DC-) MOS-HEMT with a gate recess into the upper channel layer has achieved a remarkably low Ron. In this study, we found that the double-channel structure itself does not guarantee a low Ron without careful consideration of the electrical coupling between the two channels. A strong channel-to-channel (C2C) coupling between the two channels is critical to reduce Ron in the DC-MOS-HEMT by exploiting both channels at the access region while allowing currents to converge into the heterojunction lower channel at the gate region. Otherwise, with a weak C2C coupling, the conduction through the upper channel is comprised due to the high-resistivity MOS-channel section at the gate region. The fabricated DC-MOS-HEMT with C2C distance (tC2C) of 7.5 nm exhibits an appreciably lower Ron than that with tC2C = 11.5 nm. Further analysis reveals the latter suffers from an increased sheet resistance at access region compared to the sheet resistance of the DC-heterostructure itself. A modified TLM characterization is proposed to analyze the C2C coupling in the DC-heterostructure. It is confirmed the DC-heterostructure with tC2C = 7.5 nm boasts a strong C2C coupling, while that with tC2C = 11.5 nm features relatively weak C2C coupling.