Theodore. J. Ronningen

Theodore. J. Ronningen

Auto-generated profile, based on publicly available information

Theodore. J. Ronningen

The Ohio State University

Research Focus & Metrics

Academic Career Length

29Years (1998-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 January 2023 in Optica
Verified
Journal Article
Closed access
SLSeunghyun Lee
Seunghyun Lee
XJXiao Jin
Xiao Jin
HJHyemin Jung
Hyemin Jung
HLHarry Lewis
Harry Lewis
YLYifan Liu
Yifan Liu
SKSanjay Krishna
Sanjay Krishna
High sensitivity avalanche photodiodes (APDs) operating at eye-safe infrared wavelengths (1400–1650 nm) are essential components in many communications and sensing systems. We report the demonstration of a room temperature, ultrahigh gain ( M = 278 , λ = 1550 n m , V = 69.5 V , T = 296 K ) linear mode APD on an InP substrate using a G a A s 0.5 S b 0.5 / A l 0.85 G a 0.15 A s 0.56 S b 0.44 separate absorption, charge, and multiplication (SACM) heterostructure. This represents ∼ 10 × gain improvement ( M = 278 ) over commercial, state-of-the-art InGaAs/InP-based APDs ( M ∼ 30 ) operating at 1550 nm. The excess noise factor is extremely low ( F < 3 ) at M = 70 , which is even lower than Si APDs. This design gives a quantum efficiency of 5935.3% at maximum gain. This SACM APD also shows an extremely low temperature breakdown sensitivity ( C b d ) of ∼ 11.83 m V / K , which is ∼ 10 × lower than equivalent InGaAs/InP commercial APDs. These major improvements in APD performance are likely to lead to their wide adoption in many photon-starved applications.

22 February 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SLS. Lee
S. Lee
SKS. H. Kodati
S. H. Kodati
BGB. Guo
B. Guo
LILaser Thermal Analysis Inc.
Laser Thermal Analysis Inc.
MSM. Schwartz
M. Schwartz
SKSanjay Krishna
Sanjay Krishna
We report on the demonstration of Al0.85Ga0.15As0.56Sb0.44 (hereafter, AlGaAsSb) avalanche photodiodes (APDs) with a 1000 nm-thick multiplication layer. Such a thick AlGaAsSb device was grown by a digital alloy technique to avoid phase separation. The current-voltage measurements under dark and illumination conditions were performed to determine gain for the AlGaAsSb APDs. The highest gain was ∼ 42, and the avalanche initiation occurred at 21.6 V. The breakdown voltage was found to be around −53 V. The measured dark current densities of bulk and surface components were 6.0 μA/cm2 and 0.23 μA/cm, respectively. These values are about two orders of magnitude lower than those for previously reported 1550 nm-thick AlAs0.56Sb0.44 APDs [Yi et al., Nat. Photonics 13, 683 (2019)]. Excess noise measurements showed that the AlGaAsSb APD has a low k of 0.01 (the ratio of electron and hole impact ionization coefficients) compared to Si APDs. The k of the 1000-nm AlGaAsSb APD is similar to that of the thick AlAsSb APDs (k ∼ 0.005) and 5–8 times lower than that of 170 nm-thick AlGaAsSb APDs (k ∼ 0.5–0.8). Increasing the thickness of the multiplication layer over 1000 nm can also reduce k further since the difference between electron and hole impact ionization coefficients becomes significant in this material system as the thickness of the multiplication layer increases. Therefore, this thick AlGaAsSb-based APD on an InP substrate shows the potential to be a high-performance multiplier that can be used with available short-wavelength infrared (SWIR) absorption layers for a SWIR APD.

1 March 2021 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SKS. H. Kodati
S. H. Kodati
SLS. Lee
S. Lee
BGB. Guo
B. Guo
AJA. H. Jones
A. H. Jones
MSM. Schwartz
M. Schwartz
SKSanjay Krishna
Sanjay Krishna
We report the gain, noise, and dark current characteristics of random alloy Al0.79In0.21As0.74Sb0.26 (hereafter AlInAsSb)-based avalanche photodiodes (APDs) on InP substrates. We observe, at room temperature, a low excess noise corresponding to a k value (ratio of impact ionization coefficients) of 0.018 and a dark current density of 82 μA/cm2 with a gain of 15. These performance metrics represent an order of magnitude improvement of the k-value over commercially available APDs with InAlAs and InP multiplication layers grown on InP substrates. This material is also competitive with a recently reported low noise AlAsSb on InP [Yi et al., Nat. Photonics 13, 683 (2019)], with a comparable excess noise and a room temperature dark current density almost three orders of magnitude lower at the same gain. The low excess noise and dark current of AlInAsSb make it a candidate multiplication layer for integration into a separate absorption, charge, and multiplication layer avalanche photodiode for visible to short-wavelength infrared applications.

8 November 1998 in The Journal of Chemical Physics
Verified
Journal Article
Closed access
DBDale J. Brugh
Dale J. Brugh
TRTheodore J. Ronningen
Theodore J. Ronningen
MMMichael D. Morse
Michael D. Morse
The first optical spectroscopic investigation of MoC has revealed a complicated vibronic spectrum consisting of about 35 bands between 17 700 and 24 000 cm−1. Analysis has shown the ground state to be the Ω=0+ spinorbit component of a 3Σ− state that derives from a 10σ211σ25π42δ2 configuration. The X 3Σ0+− rotational constant for 98Mo12C was determined to be B0=0.553 640±0.000 055 cm−1, giving r0=1.687 719±0.000 084 Å. Consideration of spin-uncoupling effects in the X 3Σ− state requires that this value be revised to r0=1.6760 Å, which represents our best estimate of the true Mo–C bond length. Spectroscopic constants were also extracted for six other major isotopic modifications of MoC in this mass resolved experiment. All rotationally resolved transitions were found to originate from the ground state and terminate in electronic states with Ω=1. An attempt is made to classify the observed transitions into band systems, to rationalize the complexity of the spectrum, and to understand the bonding from a molecular orbital point of view.

14 February 2022 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
SLS. Lee
S. Lee
BGB. Guo
B. Guo
SKS. H. Kodati
S. H. Kodati
HJH. Jung
H. Jung
MSM. Schwartz
M. Schwartz
SKSanjay Krishna
Sanjay Krishna
We demonstrate low noise random alloy (RA) Al0.85Ga0.15AsSb (hereafter AlGaAsSb) avalanche photodiodes (APDs) nearly lattice-matched to InP substrates. In contrast to digital alloy (DA), RAs are manufacturable due to the ease of growth. The 910 nm-thick RA AlGaAsSb was grown at a low temperature around 450 °C to mitigate phase separation by suppressing surface mobility of adatoms. The high quality of the RA AlGaAsSb material was verified by x-ray diffraction, Nomarski, and atomic force microscope images. Capacitance–voltage measurement found that the background doping concentration was 6–7 × 1014 cm−3, indicating very low impurity density in the RA AlGaAsSb material. Current–voltage measurements were carried out under dark condition and 455 nm laser illumination at room temperature. The breakdown occurs at −58 V. The dark current density at a gain of 10 was found to be 70 μA/cm2. This value is three orders of magnitude lower than previously reported DA AlAs0.56Sb0.44 APDs [Yi et al., Nat. Photonics 13, 683 (2019)], one order of magnitude lower than DA AlGaAsSb [Lee et al., Appl. Phys. Lett. 118, 081106 (2021)], and comparable to RA AlInAsSb APDs [Kodati et al., Appl. Phys. Lett. 118, 091101 (2021)]. In addition, the measured excess noise shows a low k (the ratio of impact ionization coefficients) of 0.01. These noise characteristics make the RA AlGaAsSb multiplier suitable for commercial applications, such as optical communication and LiDAR systems.

9 October 2024 in Communications Materials
Verified
Journal Article
Open access
PDF file
HJHyemin Jung
Hyemin Jung
SLSeunghyun Lee
Seunghyun Lee
XJXiao Jin
Xiao Jin
YLYifan Liu
Yifan Liu
TRTheodore. J. Ronningen
Theodore. J. Ronningen
SKSanjay Krishna
Sanjay Krishna
The rising concentration of greenhouse gases, especially methane and carbon dioxide, is driving global temperature increases and exacerbating the climate crisis. Monitoring these gases requires detectors that operate in the extended short-wavelength infrared range (~2.4 µm), covering methane (1.65 µm) and carbon dioxide (2.05 µm) wavelengths. Here, we present a high-performance linear mode avalanche photodetector (APD) with an InGaAs/GaAsSb type-II superlattice absorber and an AlGaAsSb multiplier, matched to InP substrates. This APD achieves a room temperature gain of 178, an external quantum efficiency of 3560% at 2 µm, low excess noise (less than 2 at gains below 20), and a small temperature coefficient of breakdown (7.58 mV/K·µm). These results indicate that a manufacturable semiconductor material-based APD could significantly advance high-sensitivity receivers for greenhouse gas monitoring, potentially enabling their commercial production and widespread use.