9 October 2024 in Communications Materials
The rising concentration of greenhouse gases, especially methane and carbon dioxide, is driving global temperature increases and exacerbating the climate crisis. Monitoring these gases requires detectors that operate in the extended short-wavelength infrared range (~2.4 µm), covering methane (1.65 µm) and carbon dioxide (2.05 µm) wavelengths. Here, we present a high-performance linear mode avalanche photodetector (APD) with an InGaAs/GaAsSb type-II superlattice absorber and an AlGaAsSb multiplier, matched to InP substrates. This APD achieves a room temperature gain of 178, an external quantum efficiency of 3560% at 2 µm, low excess noise (less than 2 at gains below 20), and a small temperature coefficient of breakdown (7.58 mV/K·µm). These results indicate that a manufacturable semiconductor material-based APD could significantly advance high-sensitivity receivers for greenhouse gas monitoring, potentially enabling their commercial production and widespread use.
29 May 2023 in Applied Physics Letters
Low noise avalanche photodiodes (APDs) detecting 1550 nm wavelength play a crucial role in optical communication and LiDAR systems. These APDs utilize a separate absorption, charge, and multiplication (SACM) architecture with an absorber for 1400–1650 nm detection and a low noise, high gain multiplier that can be independently optimized for a high signal-to-noise ratio. Recently, GaAs0.5Sb0.5/Al0.85Ga0.15As0.56Sb0.44 SACM APDs have demonstrated ultra-high gain and extremely low noise, possibly improving sensitivity over Si and InGaAs/InP commercial APDs. This accomplishment was achieved using a GaAsSb absorber instead of a conventional InGaAs absorber, mitigating band discontinuities between the absorber and the multiplier. However, further optimization is required to reduce noise due to tunneling and impact ionization from the GaAsSb absorber, which occurs at a high electric field region. This paper focuses on the study of the high-field characteristics of GaAsSb photodiodes (PDs). The tunneling phenomenon is analyzed through current density-voltage measurements, and the impact ionization behavior is evaluated by measuring the multiplication of p-i-n GaAsSb PDs. The result suggests that when designing a SACM APD with a GaAsSb absorber, the electric field in the absorber can be increased to 175 kV/cm without the detrimental effects of ionization occurring in the absorber. The findings from this investigation will assist in optimizing GaAsSb-based SACM APDs and promoting further advancements in the 1550 nm APD technology.
25 November 2024 in Applied Physics Letters
The application of an electric field to a semiconductor can alter its absorption properties. This electroabsorption effect can have a significant impact on the quantum efficiency of detector structures. The photocurrents in bulk InGaAs and GaAsSb p-i-n photodiodes with intrinsic absorber layer thicknesses ranging from 1 to 4.8 μm have been investigated. By using phase-sensitive photocurrent measurements as a function of wavelength, the absorption coefficients as low as 1 cm−1 were extracted for electric fields up to 200 kV/cm. Our findings show that while the absorption coefficients reduce between 1500 and 1650 nm for both materials when subject to an increasing electric field, an absorption coefficient of 100 cm−1 can be obtained at a wavelength of 2 μm, well beyond the bandgap energy when they are subject to a high electric field. The results are shown to be in good agreement with theoretical models that use Airy functions to solve the absorption coefficients in a uniform electric field.