We fabricate an operational amplifier (op-amp) composed with the coplanar amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs). The circuit consisted of 19-TFTs and designed on a glass substrate in both dual gate (DG) and single gate (SG) structure for performance evaluation.Having the yield of a total voltage gain (Av) of 23.5 dB, a cutoff frequency (fc) of 500 kHz, a unit gain frequency (fug) of 2.37 MHz, gain-bandwidth product (GBWP) of 7500 kHz, a slew rate (up/down) of (2.1/1.2) V/μs, and a phase margin (PM) of 102∘ at a supply voltage of ±10 V, the fabricated DG TFT op-amp demonstrates good performance among all a-IGZO based literature.
We report the effect of doping fluorine in the offset region on the performance of coplanar amorphous indium–gallium–zinc oxide (a-IGZO) thin-film transistors (TFTs). The TFTs with 4- $\mu \text{m}$ offset length at both sides of the gate were fabricated. Hall mobility of the offset region a-IGZO increases, and its resistivity ( $\rho $ ) decreases with increasing F doping concentration. The TFTs with $\textsf {7}\times \textsf {10}^{\textsf {19}}$ cm −3 carrier concentration in the offset region exhibit the field-effect mobility of 27.17 cm $^{\textsf {2}}/\text {V}\,{\cdot }\,\text {s}$ . The fabricated 23-stage ring oscillator (RO) shows an oscillation frequency of 2.27 MHz at the supply voltage of 20 V with a propagation delay of 9.5 ns/stage, which is the lowest value for the oxide TFT ROs ever reported.
We report the improvement of ferroelectric (FE) amorphous InGaZnO 4 (a-IGZO) thin film transistors (TFT) by Ar/O 2 plasma treatment and subsequent thermal annealing. The a-IGZO (In 2 O 3 :Ga 2 O 3 :ZnO = 1:1:1) and HZO (Hf:Zr = 1:1) layers were deposited by DC sputtering and spray coating, respectively. The Ar/O 2 plasma exposure for 10s and thermal annealing at 300°C for 15 min on the a-IGZO/HfZrO(HZO) improves the field effect mobility from 18.6 to 20.0 cm 2 V −1 S −1 , subthreshold swing from 345 to 125 mV/decade, memory window from 0.45 V to 1.0 V, and polarization from $7 ~\mu \text{C}$ /cm 2 to $9 ~\mu \text{C}$ /cm 2 . The improvement is mainly due to the reduction of oxygen vacancies at the a-IGZO/HZO interface by Ar/O 2 plasma exposure and subsequent annealing.
Thin film transistors (TFTs) with a ferroelectric Hf0.5Zr0.5O2 (HZO) gate insulator (GI) have been reported by using the vacuum process for HZO such as sputtering and atomic layer deposition methods. We report in this paper the ZnO TFT with ferroelectric GI using solution processed AlOx/HZO. AlOx assists in the initiation of ferroelectricity by applying large mechanical stress and provides a sufficient amount of oxygen vacancy to the underlying HZO. X-ray diffraction and capacitance-voltage, polarization-voltage, and anti-clockwise hystereses in the transfer curve confirm the formation of the ferroelectric phase of HZO. The AlOx/HZO TFTs exhibited a field-effect mobility of 140 cm2/V s, an on/off current ratio of 109, and a sub-threshold swing of 0.32 V/decade. The TFT shows a good bias-voltage tunable memory window of ∼4.5 V and memory retention characteristics up to 10 000 s for a programing/erasing voltage of ±10 V with a pulse width of 0.5 s. This work demonstrates the fabrication of ferroelectric HZO TFT using the solution process, and the results can be applied to ferroelectric oxide semiconductor TFT electronics.
We report the reduced strain in bendable amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistor (TFT) with dual-gate (DG) driving. The performance of the fabricated TFTs on a 15-μm polyimide substrate are sensitive to bending radius and the changes in threshold voltage (AVTH) fits well by analytical modeling. DG driving TFTs are found very stable under tensile strain (ε) compared with single-gate (SG) TFTs. Technology computer-aided design strain distribution confirms a 25% less strain on a-IGZO layer for DG TFT structure compared with SG TFT and the maximum tensile strain is observed at the center of the TFT channel. The SG and DG TFTs under 1 mm radius exhibit ΔV TH (V) shift of -1.5 and -0.3 V, respectively, from the flat state, which is due to the reduced strain in the DG TFT.
We report the recovery kinetics of drain currents for flexible amorphous indium-gallium-zinc oxide (a-IGZO) thin-film transistors (TFTs) on polyimide (PI) substrate after mechanical bending stress (MBS) of 10 4 cycles. The drain currents increase and threshold voltage shifts of -3.5 V by 1.65% tensile MBS. These shifts could be recovered by applying high drain/high gate voltages for high current. The recovery of V TH can be fitted by ΔV TH (t) = AV TH (ε, n) · [1 - exp - (t/τ) β ] with time constant τ and stretch parameter β. Positive bias recovery (PBR) under 30 V [V G = V D = 30 V] completely returns to the pristine TFT performance within 10 -3 s with τ of 5 × 10 -5 s, whereas, positive bias temperature stress [PBTS, V G = 30 V] at 60 °C exhibits a partial recovery after 1 h, with τ of 1.75 × 10 3 s. The time dependent reduction of defect states generated by MBS can be fitted well by the stretched exponential equation. The rise in temperature by Joule heating during PBR anneals out the generated defects/trapped charges.