22 September 2022 in Journal of Applied Physics
Pulsed laser deposition (PLD) is a powerful technique for prototyping thin film materials, both single component (single composition) films and films with a varying composition (e.g., lateral continuous compositional spread, CCS). In this work, we improve one of the simulation methods used to design the deposition of PLD films: We extend the mathematical model for the material spread on the substrate, , for each laser pulse hitting the target, and we use a more accurate method to determine experimentally. The deposition of the material on the substrate is simulated by repetitively adding , from one or more targets, at the selected location on the substrate. Using the new model, a high agreement between the simulated and grown films’ thickness and composition across the substrate was obtained. The basis for the high agreement is the use of variable angle spectroscopic ellipsometry to carefully determine by measuring at 794 locations on the 50.8 mm (2 in.) diameter substrates. Factors, such as variation in optical properties and porosity across the plume/calibration films, were considered in the determination of the thicknesses. As test cases, we simulated and deposited (single component) thin films and (CCS) films doped with Cr and N, deposited on 50.8 mm diameter Si wafers. The modeling and simulations are implemented in an open-source Python library, pyPLD.
9 November 2015 in Applied Physics Letters
Resonant photoemission spectroscopy is used to study the intermediate-band material Cr doped ZnS. Using resonant photoemission, we show that the intermediate-band can be characterized, revealing the filling and specific orbital character of the states contributing to the resonant photoemission signal. We demonstrate that resonant photoemission spectroscopy is a powerful approach for understanding the origin of intermediate bands in doped ZnS. The methodology can be widely extended to a large variety of materials, providing useful information towards engineering of high efficiency intermediate band solar cells and of other optoelectronic devices.
21 January 2026 in Materials Science in Semiconductor Processing
14 October 2025 in Journal of Physics: Energy
Intermediate band solar cells (IBSCs) have the potential to overcome the efficiency limit of single-bandgap solar cells. Dilute nitride III–V alloys, with splitting of the conduction band due to band anticrossing, can be used as the intermediate-band material for solar cell applications. In this work, we report on the introduction of engineered GaInNAs alloy, with low (dilute) In and N contents, as IBSC material and the comparison of the performances of GaInNAs-based and the corresponding In-free GaNAs-based IBSCs grown on GaAs (100) substrate. Introduction of a small amount of In (3%) in a GaN0.011As0.989-based IBSC was found to noticeably increase the short-circuit current, I sc, at the expense of a small decrease in the open-circuit voltage, V oc. When annealed at 750 °C for 90 s, significant enhancements in I sc and V oc are seen, especially in the In-containing solar cell. The observed In-related enhancement in cell parameters after annealing is related to In-promoted bandgap tailoring and efficient curing of carrier traps during annealing. This occurred without change in the macroscopic composition of the GaInNAs alloy, most likely by In-N bond formation upon annealing, a phenomenon which does not exist in the GaNAs alloy.