12 January 2023 in IEEE Journal of the Electron Devices Society
In this letter, AlGaN/GaN HEMTs with tall-gate-stem structures were realized to improve the power performance of Ka-band devices, and a film thinning process is adopted in the fabrication process to reduce the parasitic capacitance caused by the thick silicon nitride film. According to the S-parameter measurement results, devices owning a tall-gate-stem structure and undergoing the film thinning process have higher cut-off frequency (fT) and maximum oscillation frequency (fmax) values with lower extracted parasitic capacitance. For the load-pull measurement result, the AlGaN/GaN HEMT with a tall gate stem has improved output power density (Pout) and power added efficiency (PAE) at Ka-band. The device with the elevated stem shows a steady-state current density of 883 mA/mm and a maximum transconductance of 323 mS/mm at 20 V bias, and it achieves fT of 39.5 GHz, fmax of 112.9 GHz with the maximum PAE of 24.6 % and the maximum Pout of 6.6 W/mm at 38 GHz.
30 November 2023 in IEEE Journal of the Electron Devices Society
In this research, Γ-gated AlGaN/GaN HEMTs with different layout designs and heights of gate stems were fabricated to investigate their impacts on the noise performance in the Ka-band. First, devices with 4 types of gate peripheries were prepared to optimize the layout structure for best noise performance since the values of parasitic capacitance and resistance, which are detrimental to the noise characteristic, vary as the gate widths and the number of fingers change. The device with gate width of 4×50um achieved the optimal noise performance, minimum noise figure (NFmin) of 1.5 dB and associated gain of 6.2 dB at 28 GHz. Next, devices with different gate stem heights were fabricated following the 4×50um layout pattern. The raised gate structure was applied to reduce the parasitic capacitance of the device for RF power performance enhancement, but a taller gate stem unfortunately results in the increment of gate resistance. Therefore, the impact of stem height on NFmin remains unknown. According to the experiment results, the device with a stem height of 200 nm stands out to be a viable compromise for the noise and output power performance in the Ka-band, thus providing a positive outlook for the feasibilities of single-chip circuit integration of both LNA and PA at millimeter-wave spectrum.
1 October 2023 in ECS Journal of Solid State Science and Technology
The impact of the source resistance (RS) on the linearity of AlGaN/GaN high electron mobility transistors (HEMTs) measured by the two-tone test is investigated in this study. The theoretical analysis of the third-order intermodulation (IM3) and the third-order intercept point (IP3) of the devices was performed based on the equivalent circuit approach and the polynomial curve fitting technique. The results revealed that the suppression of IM3 level and thus the improvement of IP3 were achieved for the device with a larger RS. For the experimental verifications, three types of AlGaN/GaN HEMTs were fabricated with different layout structures and air-bridge architectures corresponding to different RS values, which were then extracted by the cold-FET method. It is concluded that a device with a shorter length of middle source pad (LMS) and a side-type air-bridge architecture tends to have a larger RS value. In this study, the 4 × 50–20 device with LMS of 20 um and a side-type air-bridge architecture demonstrated the best-measured linearity performance at 30 GHz due to the largest RS.