This paper presents the performance of three phase induction motor when magnetic wedges of different permeability are inserted in stator slots. Open slots produces variable reluctance path to the air gap flux and it reduces the output power of the machine and hence efficiency. Performance of motor without wedge and with different magnetic slot wedges i.e. cast iron, Magnoval® having different relative permeability are investigated using FEA-analysis, and the results shows that higher relative permeability materials reduces the output performance of the motor. This also validate the use of magnetic wedges of low permeability is reasonable with improved performance.
28 June 2016 in IEEE Aerospace and Electronic Systems Magazine
Based on the analytical and simulation results, a prototype LABLT motor is fabricated using aerospace grade materials. A static test is conducted and a peak torque of 2.5 Nm is achieved for an armature current of 2 A with constant torque region of ±20° mechanical. Various position commands are issued at three rate inputs namely 1 deg/s, 2 deg/s, and 3 deg/s between ±20° and the results show a position accuracy of less than 0.32°. From the experimental investigations, the motor is found suitable for driving the scan mirror at three different rates and any six different positions within the constant torque region of ±20 deg mechanical. The motor is able to control and precisely position the scan mirror in the satellite mechanism. The requirement of the scan mechanism, to drive the scan mirror with a nominal torque of 2 Nm for ±20 deg mechanical at three different scan rates and six selectable scan positions is achieved.
This paper discusses the benefits of five phase technology for domestic wind turbine direct driven BLDC generators. The performances of five phase Radial Flux Permanent Magnet BLDC Generator (RFPMG) is discussed. Multi-phase technology harnesses some important benefits such as improved fault tolerance, reliability, reduced voltage and torque ripple. This paper also discusses the design of five phase RFPMG which was optimized to use in areas where wind speed is less. Finite element analysis and Matlab / Simulink are used in the investigations. Test results are also presented in this paper.
10 January 2024 in IEEE Canadian Journal of Electrical and Computer Engineering
The performance of an internal permanent magnet MISC machine (IPMMM) is improved by its cylindrical rotor, which dampens torque ripple. Changing the stator and rotor core materials, comparing with torque values to identify efficient motor and keeping that in consent, then change the magnet material for better ripple torque. The change in the rotor materials to vary the torque by the rotor angle is analyzed. The finite element method is applied to a MISC motor operating at 290 V, 20 A, and 3000 r/min with the goals of increasing torque and decreasing torque ripple. In this machine, changing stator and rotor materials improves the torque. The results are calculated and analyzed numerically, with the results being virtualized graphically.