6 December 2022 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a curvature-compensated sub-1V voltage reference (VR) and a shared-resistive nanoampere current reference (CR) in a 130nm CMOS process. The CR is used to generate a bipolar junction transistor complementary-to-absolute-temperature voltage, which is summed up with a proportional-to-absolute-temperature voltage generated using a summing network of PMOS gate-coupled pairs. The measured output voltage and current references from 10 chips ( $V_{\mathrm {REF}}$ and $I_{\mathrm {REF}}$ ) at room temperature are 469mV and 1.86nA, respectively. The measured average temperature coefficient of $V_{\mathrm {REF}}$ and $I_{\mathrm {REF}}$ are 29ppm $/^{\circ} \text{C}$ and 822ppm $/^{\circ} \text{C}$ over a temperature range from $- 40^{\circ} \text{C}$ to $120^{\circ} \text{C}$ . The minimum supply voltage of the voltage-current reference is 0.95V, and the total power consumption is 30nW.
29 July 2021 in IEEE Transactions on Microwave Theory and Techniques
This work presents a wide-range, submicrowatt CMOS rectifier, which is designed to efficiently work at input power levels down to −31 dBm. The designed rectifier uses a novel threshold voltage compensation design, namely, the design of a custom-built single-stage rectifier that supplies a nanowatt current reference circuit. The generated bias current is mirrored to the core rectifier in order to precharge its CMOS diodes. The rectifier was optimized for a minimum number of gain stages while trying to minimize the overall input parasitic capacitance of the rectifier. The proposed CMOS rectifier was designed in an in-house 130-nm CMOS technology and includes a 1.6-kV human body level ESD protection at the input terminals. Measurements reveal a high 30% power conversion efficiency (PCE) over a wide input power range from −23 to −13 dBm for a 1- ${\mathrm{ M}}\Omega $ output load at 868 MHz. PCE of over 10% is achieved for a 1- ${\mathrm{ M}}\Omega $ load at an input power of −28 dBm. The enhanced startup at submicrowatt input power levels of the CMOS rectifier enables the design of an ultralow-power passive wake-up receiver. The measured sensitivity of −31 dBm for a 1-V output voltage across a capacitive load is the lowest reported in the literature so far.
3 August 2020 in IEEE Solid-State Circuits Letters
A pico-ampere sensitive electrochemical sensor signal acquisition chain consisting of a multi-channel bidirectional current-mirror based potentiostat and a multiplexed current-input delta-sigma (Σ) ADC is presented. Slice-based class-AB amplifiers with output stage current replication using reconfigurable current-mirrors enable bidirectional current sensing over a range of five decades. The replicated current is digitized by the ADC. The proposed circuit achieves a minimum detectable current of 91.7 pA, resulting in a dynamic range of 147 dB for sensor currents up to ±1 mA. The potentiostat is operated at a 3 V supply, the ADC at 1.5 V. The static power consumption of a single interface channel depends on the number of active amplifier slices and is between 14.1 W and 39.3 W. The highest power efficiency among similar systems and the low voltage headroom consumption of less than 500 mV enables a versatile use of the interface for multiple sensing applications.
4 August 2023 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents a fully passive RF wake-up receiver (WuRX) fabricated in a 130 nm CMOS process with a matched small loop antenna. The WuRX consists of a high-sensitivity RF energy harvester that supplies the circuitry necessary for passive WuRX functionality. The circuit consists of an on-chip voltage reference, current reference, power-on reset, low-dropout regulator, relaxation oscillator, envelope detector, comparator, and a digital processor. The WuRX supports an input bitrate of 26 kbps and has a user-defined 12-bit wake-up pattern. Measurements at 830 MHz reveal a wake-up sensitivity of -30.7 dBm and a 1 V harvested output sensitivity of -31 dBm. The RF-powered fully-passive WuRX paves the way for autonomous batteryless sensor nodes.
13 January 2026 in Journal of Power Sources