6 May 2025 in Fine Chemical Technologies
Objectives. It was recently discovered that water samples with modified physicochemical properties can be obtained by successive vibration treatment of intact water together with a solution of a substance located in separate closely spaced vials. We refer to such samples as iterations. By adding the vibrational iterations into the initial substance, the physicochemical properties of the latter are changed, i.e., they demonstrate post-vibration activity. In addition, it has been shown that vibrational iterations can be obtained using water treated with a magnetic field as the initial substance. On this basis, we may hypothesize that the phenomenon of post-vibration activity is universal. To confirm this hypothesis, water treated with an electric signal having various parameters (electrochemically activated water) was used as the initial substance for the preparation of vibrational iterations.Methods. The physicochemical properties of vibrational iterations, which were obtained from electrochemically activated water, were studied by conductometry, terahertz spectroscopy, and radiometry. The effect of the initial substance or its vibrational iterations on intact water (a neutral carrier) was evaluated by dynamic light scattering. For this purpose, the intensity of light scattering by the sample and the hydrodynamic diameter of optical heterogeneities were measured. The attenuation coefficient of an additional electric signal applied to the samples was determined.Results. The obtained vibrational iterations differ from intact water and their mixtures with intact water in terms of specific electrical conductivity, power flux density of microwave radiation, as well as in the contribution of the main (Debye) relaxation process to the overall dielectric response. Mixtures of vibrational iterations with water also differ from intact water in terms of the size of optical heterogeneities. By analogy with the vibrational iterations for which solutions of high- and low-molecular-weight substances were used as the initial substance, vibrational iterations obtained using electrochemically activated water can be classified into different groups (fractions) according to their physicochemical characteristics. Different degrees of changes in the physicochemical characteristics are observed depending on the parameters of the electric signal used to obtain the initial substance. The efficiency of electrical signal propagation in these mixtures, as estimated by the signal strength attenuation coefficient, is additionally changed. The addition of the initial substance (electrochemically activated water) to intact water also leads to changes in the physicochemical properties of the resulting mixture compared to the control. Depending on the parameters of the electric signal used to obtain the initial substance, the magnitude of changes in the physicochemical characteristics of these mixtures similarly varies.Conclusions. The fundamental possibility of obtaining vibrational iterations from electrochemically activated water similarly to vibrational iterations prepared in other studies, was demonstrated. This confirms the universality of the phenomenon of post-vibration.
31 July 2022 in Fine Chemical Technologies
Objectives. With the growing resistance of pathogenic microorganisms to antibiotics, the development of new antimicrobial drugs offering specific mechanisms of action becomes an urgent task. Only few antimicrobials offer a broad spectrum of activity against gram-positive and gram-negative bacteria, molds, and yeasts. In this regard, the purpose of the work was to develop methods for synthesizing biologically active derivatives of alkyl-substituted phenols (reactions at the hydroxy group) to study their biological effect.Methods. The synthesis of imidazole acetates of substituted phenols was carried out in two stages. At the first stage, the chloroacetyl derivative of the selected compounds was obtained, to which imidazole was then added. O-acylation reactions at the first stage of the synthesis were carried out under varying conditions. The first version of the synthesis was carried out using chloroacetyl chloride as an acylating agent together with a high-boiling solvent. In the second variant, chloroacetic anhydride was used, along with an attempt to replace the solvent with a low-boiling one. A thymol methoxy derivative was additionally synthesized by a known method using methyl iodide and varying the reaction parameters.Results. The parameters of chloroacetylation and methoxylation of aromatic alcohols were optimized with rational selection of solvents and the ratio of reagents in the reactions. Synthesized thymol (2-isopropyl-5-methylphenol) and propofol (2,6-isopropylphenol) derivatives contained imidazole as an additional pharmacophore with affinity for microorganism cell membrane proteins. A thymol methoxy derivative comprising an aromatic ether exhibiting increased hydrophobicity was also obtained. The synthesized compounds were characterized by NMR spectroscopy.Conclusions. Chloroacetyl derivatives of aromatic alcohols can be effectively synthesized by cooling the reaction mixture using an excess quantity of an acylating agent and increasing the reaction time (compared to literature data). The yield of thymol chloroacetate was 75%, while that of propofol chloroacetate was 30%. This can be explained by the sterically hindered reaction of the propofol alcohol group, which has isopropyl substituents at the second and sixth positions of the benzene ring.