Rhenium and some trace elements are different from other metals. Their importance comes from the fact that they are used in high-temperature alloys, optoelectronic devices, catalytic systems, and energy technologies. Because they are rare in nature and are often found in small amounts in copper, molybdenum, zinc, and aluminum ores, it is hard to extract them. This depends on how the metallurgical industry works and how much money it makes. This, along with the fact that the quality of the ore is getting worse, has brought to light a wider range of raw materials, such as off-gases, metallurgical dust, coal waste, and spent catalysts. Hydrometallurgical methods are the main ways to extract minerals. They include different combinations of leaching, ion exchange, solvent extraction, and sorption. Polymeric materials, particularly interpolymer hydrogel systems made of polymethacrylic acid and poly-4-vinylpyridine, have become useful for binding perrhenates and trivalent lanthanide ions in the last few years. This is because the interactions between the polymers are controlled and work together in the polymer matrix. These improvements make it possible to extract a wider range of raw materials and open up new ways to selectively extract metals at very low concentrations. This review summarizes information about the geological and anthropogenic resource base, the most common ways to get rhenium and trace elements, and the latest technological advances in processing these materials.
In this work, the processes of sorption and desorption of chromate ions from the solution obtained as a result of the processing of high-chromium ilmenite concentrate were studied using sorbents: Amberlite IR120 (Na), Amberlite IRA-35, PuroliteA-100, LewatitMono Plus M-500. The influence of pH factor and sorption system composition on the sorption process of chromate ions (VI) was investigated. Different polymers were tested to evaluate their combined effect on the recovery of chromate ions. A correlation was found between the increase in the efficiency of the sorption process of chromate ions (98%) and a decrease in pH from pH 13.5 to pH 2.5. In addition, the sorption process was improved at higher sorbent concentrations and the desorption efficiency increased at higher molar concentrations of sodium hydroxide (NaOH). The study's results will serve for the optimization of sorption processes for the extraction of chromate ions (VI) with the participation of various polymeric sorbents in the industry.
The paper presents the results of the sorption of chromium (VI) ions from solutions, obtained during the processing of high-chromium ilmenite concentrate using the simultaneous co-presence of anionite (AB-17-8(Na)) and cationite (KU-2-8(Na)). Under static conditions, the sorption behavior of two polymer hydrogels was studied at different molar ratios of polymers to determine their sorption capacity towards chromium (VI) ions. The investigated polymer systems were formed at molar ratios of KU-2-8(Na) and AB-17-8(Na), respectively: 6:0, 4:2, 3:3, 2:4 и0:6. The sorption efficiency of interpolymer hydrogel systems towards chromate ions (VI) in solutions obtained during the processing of ilmenite concentrate has been studied. An interpolymer system with two types of hydrogels: anionic (AB-17-8(Na)) and cationic (KU-2-8(Na)) was studied. Different molar ratios of these polymers were tested to evaluate their combined effect on the sorption of chromate ions. A Shimadzu atomic absorption spectrometer was used to analyze the samples. The results showed that the simultaneous presence of the two polymers in the system enhanced the efficiency of the sorption process compared to using either of them individually. It was also demonstrated that the best sorption occurred when both polymers were present, with optimum performance at a ratio of 2:4. The combined presence of anionic and cationic polymers enhances the sorption process of chromium compared to the use of either polymer alone.